User manual SIMA DAKAR PLUS

[. . . ] 18220 Albolote, Granada (SPAIN) Company responsible for manufacturing and commercialising the below specified machine: DECLARES: That the above mentioned machine designed for masonry cutting of stone and other construction materials is in conformity with all applicable provisions of the Directive of Machines (2006/42/CE) and the national applicable regulations. The machine is also in conformity with EC applicable provisions: 2006/95/CE; 2004/108/CE; 2000/14/CE; 2002/44/CE; 2002/95/CE; 2002/96/CE The machine is also in conformity with the provisions of the following applicable norms UNE-EN 292-1; UNE-EN 292 -2; UNE-EN 294; UNE-EN 349; UNE-EN 60204-1; UNE-EN 12418; UNE-EN 1050 ; UNE-EN 953. WARNING: Pease read and understand perfectly the present instruction before using the machine. Thanks you for your trust in our products and for purchasing the TABLE SAW DAKAR PLUS model This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of the present machine. [. . . ] Before starting-up the machine, we should have gone through all necessary safety measures (electrical connection, stability, protections, etc. ) as mentioned in the previous chapters. When installing the machine, make sure the table on which it will be placed should be a horizontal, non bland surface. this machine IS NOT TO BE USED UNDER RAIN AND ALWAYSE WORK IN GOOD ILLUMINATION CONDITIONS. To start cutting, the operator should stand in from of the machine. In this position, the operator can easily manage the cutting head and the piece to be cut. Once the power supply cable is connected, the motor and the water puma start-up only by pressing the green switch button. The machine can be stopped, simply by pressing the red switch button. If you wish to transform the machine from Ø300 to Ø350 or the opposite, you have to be careful with the height you want and change the position of the motor as you can cut the cart with the disk. 6) drag the cutting head until the disk touches the piece to cut. You need to start cutting slowly and maintain a constant progress in function of the material to be cut. DAKAR PLUS models have been design to performance either 90º or 45º cuts very easily. Diagonal cutting is effectuated in the same way as a right cutting: For a diagonal cutting, you need to use the ruler with a graduated semicircle (A, Fig. This ruler must rotate to look for required degrees to make the cutting. Once the degrees have been selected in the semicircle, you place the piece to cut on the cutting table marking the face of the graduated ruler as well as the front ruler upper face(Fig. To complete the cutting, proceed as per the straight cut instructions. The design of the cutter DAKAR PLUS model allows cutting maintaining the sliding cart fixed and making progress with a downward motion of the cutting unit. This mode is very useful to make interior windows in one piece. To make this type of cut we loosen the adjustable handle A, Fig. 9 till the unit is freed and the internal spring tension will draw up its highest point Then we will move the sliding cart with the work piece on to a position below the disc and proceed to cut holding the handle and pushing to cut down against the resistance of the spring. The advance shall be adjusted depending on material hardness and depth of cut (Fig. 9) Excessive reduction of the disk could potentially damage the sliding tray so the machine incorporates a screw cap (P, Fig. [. . . ] Are to be found in the spare parts plan, attached to this manual. To order any spare part, please contact our alter-sales service clearly indicating the serial number of the machine, model, manufacturing number and year of manufacturing that show on the characteristics plate. To order any spare part, please contact our alter-sales service clearly indicating the serial number of the machine, model, manufacturing number and year of manufacturing that show on the characteristics plate. Raw materials have to be collected instead of throwing away residuals. [. . . ]