User manual SIMA SCC

[. . . ] To prevent fire or shock hazard, do not expose this product to rain or moisture. Do not use near a bath tub, wash bowl, sink, or laundry tub; do not use in a wet basement or in a swimming pool. To avoid electrical shock, do not open the case of this product. Operate this product using only the power supply included with it or provided as an accessory. [. . . ] The diagram below shows how to connect between either a camcorder or VCR and a recording VCR. Step 1: Plug the 15 vdc plug into the SCC and the adapter into a standard 120 VAC outlet. Step 2: Connect the video output of the playback VCR or camcorder to the Video Input on the SCC. You can use either, but not both, of the composite or s-video connections to match the output of the VCR. Step 3: Connect the audio output of the playback VCR or camcorder to the audio inputs on your recording VCR. Step 4: Connect the video output of the SCC to the video input of the recording VCR. Typical SCC Connection Operation When AC power is applied and the power button is depressed, the power light will illuminate. You can now use the controls to adjust the picture as described below. Front Panel 5 Controls Power - Press to turn unit on or off. Tint - Adjust the hue level of the video output. Color - Adjusts the amount of color in the picture by varying the chroma level. Sharpness - Boosts or cuts the high frequency detail of the image offering a true sharpening of the picture. A special noise reduction circuit is incorporated to reduce the grain normally associated with detail enhancers. Set to about the "2 o'clock position for normal picture. Brightness - Adjusts the black level of the input video signal to brighten or darken the image. Set to about the "1 o'clock position for normal picture. Contrast - Adjusts the luminance level of the video signal. Set to the "2 o'clock position for a normal picture. Blue - Fine adjustment of the balance of the blue color in the picture Green - Fine adjustment of the balance of the green color in the picture Red - Fine adjustment of the balance of the red color in the picture Bypass - Press the button in to bypass the color corrector and out to have the color corrector in the video circuit. 6 The dots shown in the front panel view above the controls on the previous page show the setting of the controls so the picture is about equal to the input. Because of slight variations these setting should be used as a starting point only and will vary from set-up to set-up. [. . . ] Limitation of Liability and Remedies Sima shall have no liability for any damages due to lost profits, loss of use or anticipated benefits, or other incidental, consequential, special or punitive damages arising from the use of, or the inability to use, this product, whether arising out of contract, negligence, tort or under any warranty, even if Sima has been advised of the possibility of such damages. Sima's liability for damages in no event shall exceed the amount paid for this product. Sima neither assumes nor authorizes anyone to assume for it any other liabilities. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]