User manual SIMA SED-2

[. . . ] Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. Follow instructions - Follow all operating and use instructions. Water and Moisture - the appliance should not be used near water - for example: near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. Ventilation - The appliance should be located so that its location or position does not interfere with proper ventilation. [. . . ] 3, RM-18 The RM-18 IR remote control allows you to control all of the functions available from the unit's front panel, with the addition of a DIM setting. POWER ­ Toggles between Active and Standby mode. DIM - Pressing this button cycles through four levels of brightness on the front panel lights - bright, medium, dim or off. VOLUME STABILIZER ACTIVE - Toggles between the Volume Stabilizer being Active or in the Bypass mode. AUTO SCAN - Toggles between the Automatic Input Selection mode being on or off. INPUT SELECT 1 through 7 - Selects desired View input. RECORD ­ Allows the selection of the Record input. Pressing this button once will cause all of the red Record indicators to light. Pressing INPUT SELECT 1 through 7 within 3 seconds will then set the Record input. Be sure to install the two AAA batteries in the RM-18 remote before using. Slide the cover open on the remote in the direction of the arrow and install the batteries as shown inside the unit. Page 7 Typical Hook up Step 1 Connect the AC adapter to 120 VAC and plug the DC cord into the 15 VDC input on the rear of the VS712EX. Step 2 You will determine how you want to use your system. If you are using a source with s-video then you must use an s-video connection to the recording VCR and to the television. Page 10 Operation When AC power is first applied, all outputs will be muted and all the lights will come on for 1 second and then go out. The Power / Stand-by light will be lit dim red. The Auto Input and Volume Stabilization modes will be active as default. When the unit detects an active video input (composite, SVideo, or component video), the Power / Standby light will turn off full and the active input will be selected. Power As long as AC power is not lost, the previous status (last selected input, Volume Stabilizer mode and AUTO SELECT status) will be resumed when Power / Stand-by is pushed. If AC power was lost, the unit will default with input #1 (both View and Record) selected, Volume Stabilization on and AUTO SELECT on. View Inputs Pushing a view input button on either the front panel or on the IR remote, will cause the view current input and associated LED to go off and the new input to come on. If the Auto Input Mode is on, the selected input will over ride the current input until another input is selected or another input is automatically detected. Record Inputs Pushing a record input button on the IR remote, will cause the current record input and associated LED to go off and the new input to come on. To set the record input from the IR remote control, first press the record button on the remote control, which will cause all of the record input LEDs to become lit. Within 3 seconds press the number of the input you wish to direct to the record output. Auto Select Mode If the Auto Select Mode is active, the unit will select a video signal from the View video inputs. If a second input becomes active, the VS-712EX will automatically change to the new input. If you want to go to another A/V source, simply select the input using the front panel button or the remote. If you don't want the VS-712EX to automatically select an active input, turn the AUTO SELECT mode off. [. . . ] Make sure inputs and outputs are not reversed. Make sure inputs and outputs are not reversed. Push STANDBY button so unit is in the ON mode. Your TV is using both composite and S-Video inputs. [. . . ]