User manual SIMPLETECH 60000-00010-011

[. . . ] Do not connect the CellPhone cable with the modem, until the cellphone driver is installed. Install CellPhone Driver in the modem flash memory by running the provided software. Connect the modem with the cellphone using the Cellphone cable. The CellPhone must be switched off while connecting with the cable. [. . . ] Please note that you need to run the Modem Upgrade utility only once, unless you need to install some different CellPhone model. Page 7 The software will test for presence of modems on different COM ports. If the following message appears, click Yes to continue. When the following message appears, click on Yes. Page 8 10. The Load Driver window appears as shown below. Select the appropriate cellphone model and Firmware list (e. g. , Select 1510C_US. 336 for 33. 6 kbauds) and click on load driver. The driver is downloaded into the modem flash memory. Once the driver is downloaded, there is no need to download the driver again unless you change cellphone models. CAUTION Please DO NOT cancel the download, once you have started loading the driver. Cancelling abruptly may damage the firmware on the modem. Even if you need to change the driver, wait until the download process is completed and then load the appropriate driver. 11. After the driver is downloaded, the following screen appears. Once the driver is downloaded, AutoLine Setup automatically configures the modem for cellular use. So there's no need to reboot each time you switch between a telephone and a cellular connection. Exit the Load Driver window by choosing Exit. Page 9 12. Once the appropriate drivers are loaded and the modem is reset, the following message appears to indicate that the firmware upgrade is complete. The cellphone driver update installation for PC Card modem is complete. The AutoLine setup will automatically detect whenever you use the modem with a cellphone. So, there is no need to run the modem upgrade utility, unless you need to use a different CellPhone model. After the firmware upgrade is complete, connect the cellphone to the modem using the cellphone cable. Page 10 4. Using the CellPhone with Cellphone cable Switch off the CellPhone, insert the modem PC Card in the PCMCIA slot and connect the Cellphone to the modem using the cellphone cable. Then switch on the CellPhone and Use the modem as directed in the documentation that came with the modem. If you are using the dialup networking through cellular phone, please read the following section to modify the dialup networking settings for cellular connection. 4A. Modifying Dialup Networking for Cellular Connection 1. [. . . ] ("STI"), warrants that this product will be free from defects in materials and workmanship during the warranty period, and will perform according to product documentation. This warranty is expressly limited to product repair or replacement, at the sole discretion of STI. Except for the express warranty expressed above, STI grants no other warranty. All implied warranties of merchantibility and fitness for a particular purpose are expressly disclaimed and are not applicable to the product. [. . . ]