User manual SIMPLETECH 60000-00020-003

[. . . ] If you find that the SimpleJack connector is not appropriate for your application, you may purchase a line access cable (P/N STI-FAX/CCBL). Call 1-800-4SIMPLE for ordering information. Refer to the User Guide for instructions on how to install the line access cable. 5 Use the 33. 6 Communicator with SimpleJack with your favorite Windows NT communications software. [. . . ] 5 You can remove the 33. 6 Communicator with SimpleJack when done. It is recommended that you stop the 33. 6 Communicator with SimpleJack before removing the 33. 6 Communicator with SimpleJack. Double-click on the PCMCIA icon located on the right of the task bar; B. Select the socket in which the 33. 6 Communicator with SimpleJack is plugged; C. When prompted, push the eject button on the computer (if applicable) and pull the 33. 6 Communicator with SimpleJack from the socket. Page 2 Simple Installation Guide Installation with Windows 3. x For installations with Windows NT, Windows 95, OS/2 Warp or MacOS, refer to the other pages. 1 Check for Card and Socket Services Release 2. 1 or Higher. While booting your computer, press <F8>. With MS-DOS 6 or higher, this will load the drivers in CONFIG. SYS one line at a time. When prompted, press "Y" to load each driver and look for messages indicating that Socket Services Release 2. 1 (or higher) and Card Services Release 2. 1 (or higher) are loading. If you require Card and Socket Services, contact your computer manufacturer for a copy and install Card and Socket Services before continuing. If you have Card and Socket Services installed, let the computer boot to the DOS prompt. 2 Plug in the 33. 6 Communicator with SimpleJack. The computer may respond with a tone when the computer recognizes the 33. 6 Communicator with SimpleJack. Lift the hinged top of the SimpleJack connector and attach a phone line. If there is no room to open the jack, slide the jack out and attach the jack to the connector on the right; then, attach the phone line. If you find that the SimpleJack connector is not appropriate for your application, you may purchase a line access cable (P/N STI-FAX/CCBL). Call 1-800-4SIMPLE for ordering information. Refer to the User Guide for instructions on how to install the optional line access cable. To attach to a cellphone. Attach the optional cellphone cable to the connector on the left. Connect the other end of the cellphone cable to your cellphone. Refer to the Quick Installation Guide that came with the cellphone cable for instructions on how to install the cellphone driver. ! If both cellphone and phone lines are attached, the 33. 6 Communicator with SimpleJack will use the cellphone and ignore the phone line. 4 Install and start the communications software. Refer to the installation sheet that came with the communications software for instructions on how to install and start the communications software. [. . . ] Call 1-800-4SIMPLE for ordering information. Refer to the User Guide for instructions on how to install the line access cable. 4 Install and start the communications software. Refer to the installation sheet that came with the communications software for instructions on how to install and start the communications software. [. . . ]