User manual SINGER 12K22

[. . . ] To disconnect, turn all controls to the off («0») position, then remove plug from outlet. Basically, the machine should be disconnected from the electricity supply when not in use. This appliance is provided with double insulation (except USA/CANADA). See instructions for servicing of double insulated products. DANGER To reduce the risk of electric shock: 1. [. . . ] Bring the thread up from the spool and lay it from the back to the front into the guide. Take the thread under the thread guide plate, through the take up and into the guide. Thread the needle R from front to back and lay the thread to the left under the foot. 43 8 8 2500_DCE_2_englisch_neu 09. 10. 2007 15:00 Uhr Seite 44 Threading 4-thread cover stitch Cover stitch needle C (green markings) 1 Place the spool on the spool pin as illustrated. 2 2 44 3 5 6 7 4 1. Bring the thread up from the spool and lay it from the back to the front into the guide. Take the thread under the thread guide plate, through the take up and into the guide. Thread the needle C from front to back and lay the thread to the left under the foot. 44 44 8 8 2500_DCE_2_englisch_neu 09. 10. 2007 15:00 Uhr Seite 45 Threading 4-thread cover stitch Cover stitch needle L (yellow markings) 1 Place the spool on the spool pin as illustrated. 2 2 4 4 3 5 6 74 1. Bring the thread up from the spool and lay it from the back to the front into the guide. Take the thread under the thread guide plate, through the take up and into the guide. Thread the needle L from front to back and lay the thread to the left under the foot. 45 8 After threading Lower the presser foot and close the looper cover. Switch the power switch to on «1». Test sew: Place a piece of fabric under the presser foot and needles, begin sewing. 8 When sewing is complete, raise the needles by turning the handwheel away from you (clockwise). Press needle stop button to lower the needles. Switch the power switch to off «O». Bring the thread up from the spool and lay it from the back to the front into the guide. Holding the thread in both hands, thread the first guide located behind the machine head. Take the thread through the groove indicated by arrows on the cover (see diagram). Bring the thread into the guide and eyelet, make sure that the thread is in the tension discs by pulling it firmly with both hands (see diagram). Thread the eyelet of the feeding link (see diagram). Pull the thread over the wiper and in front of the needles and then place it under the presser foot (see diagram). Lower the presser foot and the finger guard. Turn the handwheel towards you one or two revolutions, this will thread the wiper, turn the power switch to on «l», begin sewing. CAUTION: Check to be sure the finger guard is in its lowest fixed position. 48 2500_DCE_2_englisch_neu 09. 10. 2007 15:00 Uhr Seite 49 Threading 4-thread top & bottom cover stitch (5mm) Top & bottom cover stitch thread (grey markings) Test sewing with 3 thread (2-needles, 5mm) cover stitch has been completed. [. . . ] Thread overlock looper(s) according to stitch selected. Lower the upper knife arm and upper knife if necessary. Close the looper cover and attach the waste collector. Adjust the stitch length, differential feed and cutting width to suit stitch and fabric. [. . . ]