User manual SINGER 144WSV38

[. . . ] Indicator Light for Electric Hot Plate (only on certain models) 5 4 2 3 A B C How To Use Your Appliance The position of the corresponding gas burner is indicated on each control knob. gas Burners The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresonding control knob by using one of the following settings: • Off High Low To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn in the counter-clockwise direction to the "High" setting. [. . . ] € The gas holes are not clogged in the area corresponding to the safety device. The burner does not remain on when set to "Low". Check to make sure that: • The gas holes are not clogged. € There are no draughts near the cooking surface. • The minimum has been adjusted correctly (see the section entitled , "Minimum Regulation"). Check to make sure that: • The bottom of the cookware is perfectly flat. • The cookware is centered correctly on the burner. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. Opening a window or increasing the power of the air intake system (if present). D) Liquidified petroleum gases are heavier than air and, as a result, settle downwards. Rooms in which LPG tanks are installed must be fitted with ventilation openings to the outside in order to allow the gas to escape in the event of a leak. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50°C. Installation of Built-in Cooktops The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50°C above room temperature. For proper installation of the cooker, the following precautions must be taken: a) If the cabinet(s) located next to the cooktop are higher than the cooktop itself, the cabinet(s) must be installed at least 600 mm from the edge cooktop; b) Hoods must be installed in accordance with the instructions contained in the installation manual for the hoods themselves, and no less than 650 mm from the 12 In a chimney stack or branched flue. (exclusively for cooking appliances) Directly to the Outside b) The room must also allow for the influx of the air needed for proper combustion. [. . . ] Clamps are provided to fasten the cooktop to counters measuring from 20 to 40 mm in thickness. To fasten the cooktop securely, it is recommended that all the clamps be used. Fastening Clamps - Assembly Diagram Clamp Position for H=30mm top Clamp Position for H=40mm top 13 Gas Connection for Cooktop The cooktop should be connected to the gas supply by an authorized installer. In the case of installation over a built-in electric oven, the electrical connections for the cooktop and oven should be independent, not only for safety purposes, but also to facilitate removal of one or both in the future. [. . . ]