User manual SINGER 145W202

[. . . ] The latter can be identified by a red boss in the center of the hot plate itself. electric Hot Plates (only on certain models) The hot plates vary in diameter and power: "normal" and "fast". When the knob is on any of the settings other than "Off", the "H" operating light comes on. 9 How to Keep Your Cooktop in Shape Before cleaning or performing maintenance on your appliance, disconnect it from the electrical power supply. [. . . ] The burner does not remain on when set to "Low". Check to make sure that: • The gas holes are not clogged. € There are no draughts near the cooking surface. • The minimum has been adjusted correctly (see the section entitled , "Minimum Regulation"). Check to make sure that: • The bottom of the cookware is perfectly flat. • The cookware is centered correctly on the burner or electric hot plate. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. Safety Is a Good Habit to Get Into To maintain the EFFICIENCY and SAFETY of this appliance, we recommend: • call only the Service Centers authorized by the manufacturer • always use original Spare Parts • • This manual is for a class 3 built-in cooktop. D) Liquidified petroleum gases are heavier than air and, as a result, settle downwards. Rooms in which LPG tanks are installed must be fitted with ventilation openings to the outside in order to allow the gas to escape in the event of a leak. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50°C. Installation of Built-in Cooktops The gas cooktops are equipped with type X degree protection against overheating. Therefore, the appliance can be installed next to cabinets, provided the height of the cabinet does not exceed that of the hob. For proper installation of the cooktop, the following guidlines must be followed: a) If the cabinet(s) located next to the cooktop are higher than the cooktop itself, the cabinet(s) must be installed at least 600 mm from the edge cooktop; b) Hoods must be installed in accordance with the instructions contained in the installation manual for the hoods themselves, and no less than 650 mm from the cooktop; c) The cabinets installed next to the hood must be located at a height of at least 420 mm from the top, (as shown in Fig. (exclusively for cooking appliances) Directly to the Outside b) The room must also allow for the influx of the air needed for proper combustion. The flow of air for combustion purposes must not be less than 2 m³/h per kW of installed capacity. The supply of said air can be effected by means of direct influx from the outside through a duct with a inner cross section of at least 100 cm² which must not be able to be accidentally blocked. [. . . ] € Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new type of gas. (See table 1 , “Burner and Nozzle Specifications”). € Reassemble the parts following the instructions in reverse order. € On completing the operation, replace the old rating label with the one showing the new type of gas; the sticker is available from our Service Centres. [. . . ]