User manual SINGER 14K15

[. . . ] electric Hot Plate (only on certain models) The hot plate can be: "normal" and "fast". When the knob is on any of the settings other than "Off", the "H" operating light comes on. 10 How to Keep Your Cooktop in Shape Before cleaning or performing maintenance on your appliance, disconnect it from the electrical power supply. electric Hot Plate (only on certain models) The hot plate can be: "normal" and "fast". [. . . ] Check to make sure that: • The bottom of the cookware is perfectly flat. • The cookware is centered correctly on the burner or electric hot plate. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. 12 Safety Is a Good Habit to Get Into To maintain the EFFICIENCY and SAFETY of this appliance, we recommend: • call only the Service Centers authorized by the manufacturer • always use original Spare Parts • • This manual is for a class 3 built-in cooktop. This appliance is designed for non-professional use in the home and its features and technical characteristics must not be modified. These instructions are only valid for the countries the symbols for which appear on the manual and the serial plate. The electrical system of this appliance is safe only when it is correctly connected to an adequate earthing system, as required by current safety standards. Trying to install or repair the appliance without the assistance of qualified personnel. D) Should the cooktop be installed directly under a cupboard, the latter should be at least 700 mm (millimetres) from the top, as shown in Figure. (exclusively for cooking appliances) Directly to the Outside b) The room must also allow for the influx of the air needed for proper combustion. The flow of air for combustion purposes must not be less than 2 m³/h per kW of installed capacity. The supply of said air can be effected by means of direct influx from the outside through a duct with a inner cross section of at least 100 cm² which must not be able to be accidentally blocked. Those appliances which are not fitted with a safety device to prevent the flame from accidentally going out must have a ventilation opening twice the size otherwise required, i. Otherwise, the room can be vented indirectly through adjacent rooms fitted with ventilation ducts to the outside as described above, as long as the adjacent rooms are not shared areas, bedrooms or present the risk of fire (Fig. A e) The dimensions of the cutout for the appliance must be those indicated in the figure. Clamps are provided to fasten the cooktop to counters measuring from 20 to 40 mm in thickness. To fasten the cooktop securely, it is recommended that all the clamps be used. Enlarging the ventilation slot between window and floor. 475 mm 555 mm When installing the cooktop above a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately. [. . . ] € Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new type of gas. (See table 1 , “Burner and Nozzle Specifications”). € Reassemble the parts following the instructions in reverse order. € On completing the operation, replace the old rating label with the one showing the new type of gas; the sticker is available from our Service Centres. [. . . ]