User manual SINGER 14K9

[. . . ] H Indicator Light for Ceramic Glass Module I Ceramic Glass Module (only on certain models) F D I A B C H C How To Use Your Appliance The position of the corresponding gas burner or electric hot plate (if present) is indicated on each control knob. The “separate double flame” burner This burner consists of two concentric burners which can operate either together or separately. Use of the double flame on the maximum setting gives a very high power which reduces cooking times with respect to conventional burners. Moreover the double flame crown provides a more uniform distribution of heat on the bottom of the pan, when using both burners on minimum. [. . . ] Therefore, you will not achieve best results when using these pots on the ceramic glass surface. Notice: The glue used to seal the glass surface may leave traces on the appliance. We recommend that the module be cleaned with a non-abrasive cleaner before being used the first time. During the first few hours of use, you may detect the smell of rubber; this will disappear after a short time. It may occur that the cooktop does not function or does not function properly. Before calling customer service for assistance, lets see what can be done. First of all, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. The burner does not light or the flame is not uniform around the burner. Check to make sure that: • The gas holes on the burner are not clogged; • All of the movable parts that make up the burner are mounted correctly; • There are no draughts around the cooking surface. The flame does not stay lighted on the model with the safety device. Check to make sure that: • You press the knob all the way in; • You keep the knob pressed in long enough to activate the safety device. Always check to make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use; Cut the power supply cord after disconnecting it from the electrical mains when you decide to no longer use the appliance. The manufacturer will not be held liable for any damages arising out of : incorrect installation or improper, incorrect or unreasonable use. Installation Instructions for built-in The following instructions are directed at the qualified installer so that the installation and maintenance proceedures may be followed in the most professional and expert manner possible. Important: Unplug the electrical connection before performing any maintenance or regulation upkeep work. Positioning for gas hob Important: this unit may be installed and used only in permanently ventilated rooms according to the British Stancards Codes Of Practice: B. The following requirements must be observed: a) The room must be fitted with a ventilation system which vents smoke and gases from combustion to the outside. This must be done by means of a hood or electric ventilator that turns on automatically each time the hood is operated. Are not fitted with a safety device to prevent the flame from accidentally going out must have a ventilation opening twice the size otherwise required, i. Otherwise, the room can be vented indirectly through adjacent rooms fitted with ventilation ducts to the outside as described above, as long as the adjacent rooms are not shared areas, bedrooms or present the risk of fire (Fig. Enlarging the ventilation slot between window and floor. B c) Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e. [. . . ] Only use pipes and sealing gaskets that that conform to the standards currently in force. The maximum length of the flexible pipes must not exceed 2000 mm. Once the connection has been made, ensure that the flexible metal tube does not touch any moving parts and is not crushed. Check the Seal Once the appliance has been installed, make sure all the connections are properly sealed, using a soapy water solution. [. . . ]