User manual SINGER 17-31

[. . . ] 20 mm COMPARTMENT Positioning  Keep all packaging material out of the reach of min.  The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. • If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. [. . . ] GB  A few seconds after the hob is connected to the electricity supply, a buzzer will sound.  If the period of time, the display scrolls quickly though the power levels and timer minutes. - + or Heating elements Two types of heating element may be installed, depending on the appliance model: halogen and radiant elements. Halogen elements emit heat via radiation from the halogen lamps they contain. They have similar properties to gas burners: they are easy to control and reach set temperatures quickly, allowing you to see the power level instantly. Radiant elements consist of a series of coils which allow heat to be distributed evenly at the base of the cookware, so that all slow-flame cooking may be performed successfully, for example stews, sauces or reheated dishes. Button is pressed for an extended Switching on the hob To switch the hob on, press and hold the for approximately one second. Button Switching on the cooking zones Each cooking zone is controlled using a selector button and a power adjustment device consisting of power level selector buttons between the values of 0 and 9. • To begin operating a cooking zone, press the corresponding control button and set the desired power level using the power level selector buttons between 0 and 9. Programming the cooking duration  All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. The programme resets and the display exits programming mode. - + and buttons button: the + and buttons and Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer indicator light is illuminated. Set the desired duration using the buttons. Confirm by pressing the • The display will show the text DE and MO and the hob will be switched off. • When the hob is switched on again it will be set to the “demo” mode. If the indicator light is flashing, it may indicate: • An incompatible pan • A pan whose diameter is too small • The pan has been removed from the hotplate. Residual heat indicators Each cooking zone is equipped with a residual heat indicator. This indicator signals which cooking zones are still at a high temperature. If the power display shows , the cooking zone is still hot. [. . . ] For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. 11 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. [. . . ]