User manual SINGER 51W53

[. . . ] This appliance must not be installed outdoors - not even in an area protected by a roof. It is extremely dangerous to leave it exposed to rain or storms. It must only be used by adults and exclusively to refrigerate and freeze foodstuffs, following the instructions for use contained in this manual. Do not ever touch or handle the appliance with bare feet or with wet hands or feet. [. . . ] Remember to cool hot food before storing otherwise the temperature inside the appliance will increase, causing the compressor to work harder and use more energy. Do not store liquids in unsealed containers since this will increase the humidity and lead to the formation of frost in the refrigerator. B B B A 1 2 A A - Blown air which is cooled when it comes into contact with the refrigeration panel B - Hotter air is drawn in When the fridge compartment is filled up after a heavy shopping spree, use the Quick Cool function (press button "A" to enable it) in order to reach optimum operating conditions quickly. Once the necessary time has elapsed, the function is disabled automatically. 1 GB 16 To use the cold cuts/cheese box, unhook it and remove it from the shelf. To optimise space according to your needs, the same can be moved laterally (Fig. 3) on the inner door allows you to store not only cans, but also yoghurt, butter and other containers, according to your requirements. Using the "Fresh box" compartment for meat and fish This compartment was designed to allow for longer preservation times for fresh meat and fish (for as long as a week). This is possible as the coldest temperature of the entire fridge is available inside this specific compartment. The clear protective door to open the compartment avoids any oxidation or blackening to occur, which are typical of meat and fish when exposed to air. Moreover, the "Fresh box" compartment can also be used to cool dishes that are normally eaten "cold", such as melon and Parma ham, figs and ham, mozzarella and tomatoes. 17 GB Ice trays This new concept of ice trays is an exclusive Merloni patent. To remove the ice trays from their housings, push the tray upwards and then pull it out (fig. To put the tray back in place, insert the top part into the special housing and, once in a vertical position, just let it drop into place. Once the ice has formed, all you need to do is to knock the tray against a hard surface so that the ice cubes come away from their housing and come out of the same hole used to fill the tray with water. To make it easier for the ice cubes to come out, wet the outside of the tray. WARNING: every time you fill up the ice tray with water , make sure that the same is completely empty and that there are no traces of ice left inside it. The minimum time required for ice to form well is approximately 8 hours. 5) Fill up the tray with water via the special hole up to the level indicated (MAX WATER LEVEL), taking care not to exceed it: inserting more water than is necessary will lead to the formation of ice which could obstruct the exit of the ice cubes. If you have used an excessive amount of water, you will have to wait until the ice has melted, empty out the tray and re-fill it with water. To raise the temperature to the proper level again, the motor must work for a long time, consuming energy. - Keep an Eye on the Seals Keep the seals clean and make sure that they adhere well to the door. [. . . ] How to defrost the freezer compartment - Remove the frost from time to time with the aid of the special scraper provided (do not use knives or metal objects). - If the frost is more than 5 mm thick, then you must defrost the freezer completely. Proceed as follows: one day beforehand, press the freezing button "G" until the yellow lamp "E" comes on; it helps give the food a healthy extra "cold shock". After 24 hours, the button switches itself off automatically, yet you can switch it off yourself just be pressing it again. [. . . ]