User manual SINGER 521C DATASHEET

[. . . ] 19 Delay start/Time remaining indicator . 20 USER MAINTENANCE Instructions Cleaning and care . 43 2 Guide to the machine Guide to the machine 1 Supply cable 2 High pressure intake hoses 3 Flexible drain hose, with detachable swivel elbow 4 Detergent dispenser drawer 5 Control panel 6 Drum door 7 Access panel for lint filter and drain pump 8 Four height adjustable legs 3 Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. Compartment p (with lid) - for fabric softener or starch. b "Delay start" button. [. . . ] ^ If necessary, the drum can be cleaned using a stainless steel cleaner according to the manufacturer's instructions. A stainless steel cleaner specially formulated for use in washing machines is available from the Miele Technical Service Department. Do not use abrasive cleaners or solvents. ^ Clean the dispenser compartments and the fabric softener duct. Cleaning the detergent drawer Should the detergent drawer become clogged or dirty, it can be cleaned as follows: ^ Pull the drawer out until it stops. ^ Remove the siphon tube from compartment p and rinse in warm water. ^ Press down the red release lever and pull the drawer out of the machine. 21 Cleaning and care Cleaning the drain pump and lint trap Occasionally small objects, (buttons, coins, etc. ), may find their way into the lint trap. If the machine does not drain completely, the lint trap should be checked to ensure that it is free of foreign objects. ^ Place a 2 quart (2l) capacity container underneath the drain tube. ^ Turn the lint trap lid counterclockwise 2 - 3 times. 2 quarts (2 l) of water will drain out of the hose. If the main drain hose is clogged, more water will be retained in the machine (max. In this case, tighten the lint trap lid and empty the dish before repeating the procedure as often as necessary. Caution: If laundry has been washed at a high temperature, the water draining out of the machine will still be hot!Stop and allow it to cool before proceeding. To clean the lint trap, remove the tool from behind the detergent dispenser drawer. ^ Open the lint trap door. 22 Cleaning and care ^ Once the flow of water stops, remove the lint trap and clean it. ^ Clean the inside of the lint trap housing. ­ The inlet hose is The water inlet is blocked. The "Check q" indicator ­ Clean the drain pump and lint trap. ­ Has the drain hose been installed too high?(max drain height = 4 feet) 25 Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing? Cause . . There is an internal problem. Remedy . If the indicator lamp starts flashing again, call the Service Dept. Select a spin speed setting. ­ Redistribute the laundry load. ­ Turn the program selector to "Spin". The child-safety feature is Go back to the program . The "ON" indicator activated, and the prooriginally selected. [. . . ] The program will, however, continue uninterrupted. This prevents children from inadvertently changing or stopping a wash program by playing with the dials. If the Program Selector is turned to its original position, the "On" lamp will stop flashing. To change a program once the Program Lock is activated: ^ Turn the Program Selector to "Finish/Start". [. . . ]