User manual SINGER 541C DATASHEET

[. . . ] 19 Delay start/Time remaining indicator . 20 USER MAINTENANCE Instructions Cleaning and care . 30 INSTALLATION INSTRUCTIONS Installation . 43 2 Guide to the machine Guide to the machine 1 Supply cable 2 High pressure intake hoses 3 Flexible drain hose, with detachable swivel elbow 4 Detergent dispenser drawer 5 Control panel 6 Drum door 7 Access panel for lint filter and drain pump 8 Four height adjustable legs 3 Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. [. . . ] Deleting the start delay ­ When the display reaches "9 h 30 min", press the button to the left of the "Delay start" lamp and the delay will be deleted. Remaining time The display will count down the time remaining in the wash program in one minute increments as soon as: ­ A program is selected, or ­ The time delay reaches zero. 20 Cleaning and care Cleaning and care To clean the washing machine: ^ Clean the casing using a mild nonabrasive detergent or soap and water, and wipe dry with a soft cloth. ^ Clean the control panel with a damp cloth. ^ If necessary, the drum can be cleaned using a stainless steel cleaner according to the manufacturer's instructions. A stainless steel cleaner specially formulated for use in washing machines is available from the Miele Technical Service Department. Do not use abrasive cleaners or solvents. ^ Clean the dispenser compartments and the fabric softener duct. Cleaning the detergent drawer Should the detergent drawer become clogged or dirty, it can be cleaned as follows: ^ Pull the drawer out until it stops. ^ Remove the siphon tube from compartment p and rinse in warm water. ^ Press down the red release lever and pull the drawer out of the machine. 21 Cleaning and care Cleaning the drain pump and lint trap Occasionally small objects, (buttons, coins, etc. ), may find their way into the lint trap. If the machine does not drain completely, the lint trap should be checked to ensure that it is free of foreign objects. ^ Place a 2 quart (2l) capacity container underneath the drain tube. ^ Turn the lint trap lid counterclockwise 2 - 3 times. 2 quarts (2 l) of water will drain out of the hose. If the main drain hose is clogged, more water will be retained in the machine (max. In this case, tighten the lint trap lid and empty the dish before repeating the procedure as often as necessary. " The "Check p" indicator ­ The inlet valve is not opened far enough. lamp is flashing, and the program has started. ­ The inlet hose is The water inlet is blocked. The "Check q" indicator ­ Clean the drain pump and lint trap. ­ Has the drain hose been installed too high?(max drain height = 4 feet) 25 Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing? Cause . . There is an internal problem. Remedy . If the indicator lamp starts flashing again, call the Service Dept. Select a spin speed setting. ­ Redistribute the laundry load. ­ Turn the program selector to "Spin". [. . . ] The following additional functions can be programmed into the machine if desired: D Program Lock (Child Safety Feature) When activated, the washing machine will ignore any changes made after the first three minutes of operation. For example, if the Program Selector is moved to a different setting or an additional function is selected after the first three minutes, the "On" lamp will flash, notifying you that the Child Safety Feature has been activated. The program will, however, continue uninterrupted. This prevents children from inadvertently changing or stopping a wash program by playing with the dials. [. . . ]