User manual SINGER 635D DATASHEET

[. . . ] Compartment p (with lid) - for fabric softener or starch. a "Delay start" button. c "Door" button; opens the drum door. d "ON/OFF" button; Turns the machine on and off or interrupts a program. The "On" lamp illuminates. e Pushbuttons for additional functions. [. . . ] ^ Turn the lint trap lid counterclockwise 2 - 3 times. 2 quarts of water will drain out of the hose. ^ To clean the lint trap, remove the tool from behind the detergent dispenser drawer. If the main drain hose is clogged, more water will be retained in the machine (max. In this case, tighten the lint trap lid and empty the dish before repeating the procedure as often as necessary. Caution: If laundry has been washed at a high temperature, the water draining out of the machine will still be hot!Stop and allow it to cool before proceeding. ^ Open the door. 22 Cleaning and care ^ Once the flow of water stops, remove the lint trap and clean it. ^ Clean the inside of the lint trap housing. ^ Turn the drain pump impeller (in the back of the chamber) by hand to check that it rotates freely. Remove any detergent deposits or foreign objects from the thread of the filter housing and filter unit before replacing the lint trap. 23 Cleaning and care Cleaning the water inlet filters The washing machine has two water intake filters to protect the intake valves. ­ one in the open end of the intake hose. ­ and one where the hose is connected to the machine only to be cleaned by a technician. The "Final spin" indicator lamp is flashing? Cause . . There is an internal problem. Remedy . If the indicator lamp starts flashing again, call the Service Dept. Select a spin speed setting. The spin speed selector has been set to "Without final spin". The final spin has not ­ Redistribute the launtaken place. ­ Turn the program selector to "Spin". The child-safety feature is activated, and the program has been changed. The wash is too wet The spin speed selected after the final spin?The load was not evenly distributed in the drum, and the laundry was spun at a reduced speed to protect the machine. The machine The four feet are not restshakes during the spin ing evenly on the floor. The shipping struts have not been removed. The "ON" indicator lamp is flashing? Go back to the program originally selected. [. . . ] This prevents children from inadvertently changing or stopping a wash program by playing with the dials. If the Program Selector is turned to its original position, the "On" lamp will stop flashing. To change a program once the Program Lock is activated: ^ Turn the Program Selector to "Finish/Start". After about 30 seconds, the sequence indicator lamps will start flashing in succession. [. . . ]