User manual SINGER 655D DATASHEET

[. . . ] 19 Delay start/Time remaining indicator . 20 User-Maintenance Instructions Cleaning and Care . 31 Installation Instructions Installation . 47 2 Guide to the machine Guide to the machine 1 Supply cable 2 High pressure inlet hoses 3 Flexible drain hose, with detachable swivel elbow 4 Detergent dispenser drawer 5 Control panel 6 Adapter strips 7 Inner door panel 8 Four height adjustable legs 9 Access panel for lint filter and drain pump 10 Access panel for emergency drain and door release 3 Guide to the machine Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. [. . . ] Caution: If laundry has been washed at a high temperature, the water draining out of the machine will still be hot!Stop and allow it to cool before proceeding. Open the lint trap door. 22 Cleaning and Care Cleaning and Care Once the flow of water stops, remove the lint trap and clean it. Remove any foreign objects or lint. Clean inside of the lint trap housing. Remove any detergent deposits or foreign objects from the thread of the filter housing and filter unit before replacing the lint trap. Turn the drain pump impeller (in the back of the chamber) by hand to check that it rotates freely. Any foreign objects should be removed. 23 Cleaning and care Cleaning and care Cleaning the water inlet filters. The washing machine has two water inlet filters to protect each inlet valve. To clean the filter in the inlet hose: Turn off the valve. Carefully unscrew the inlet hose from the valve by turning the connector counterclockwise using a wrench if necessary. Remove the rubber seal from the connector. Inspect the inlet hose regularly. The hose should be replaced if there are small cracks in the surface, or if it has been otherwise damaged or cut. If a replacement is necessary, use only a genuine Miele inlet hose as other hoses may burst under pressure. To clean the filter in the inlet valve: Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. Using needle nose pliers, grasp the plastic filter and pull it out of the hose connector. ­ Turn the program selector to "Spin". Go back to the program originally selected. Mix large and small items in a load to avoid imbalance. . The "ON" indicator lamp is flashing?The wash is too wet after the final spin? The child-safety feature is activated, and the program has been changed. The load was not evenly distributed in the drum, and the laundry was spun at a reduced speed to protect the machine. The drain pump or lint trap is clogged. Clean the drain pump or lint trap. Level the machine (see Installation Section). The machine shakes during the spin cycle? The four feet are not resting evenly on the floor. The shipping struts have not been removed. 26 Problem solving guide Problem solving guide What to do if, . In spite of adequate water A filter in the water inlet system supply, the water flows slowly is blocked. [. . . ] STRUCTIONS before operating this If the program selector switch is turned appliance. to its original position, the "On" lamp will stop flashing. Additional functions can be programmed into the machine if desired: To change a program once the Program lock is activated: A High water level (only in "Cottons" rinses) Turn the program selector switch to "Finish/Start". The sequence indicator lamps will start flashing in succession after about 30 seconds. [. . . ]