User manual SINGER MC3223

[. . . ] Switch the sewing machine off ("O") when making any adjustments in the needle area, such as threading needle, changing needle, threading bobbin, or changing presser foot, and the like. Always unplug sewing machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction manual. Never drop or insert any object into any opening. Do not operate where aerosol spray products are being used or where oxygen is being administered. [. . . ] (8) 18 EN Raising the Bobbin Thread Hold the upper thread with the left hand. Turn the handwheel (1) towards you (counterclockwise) lowering, then raising needle. Note: If it is difficult to raise the bobbin thread, check to make sure the thread is not trapped by the hinged cover or the removable accessory storage. 1 Gently pull on the upper thread to bring the bobbin thread up through the needle plate hole. (2) Lay both threads to the back under the presser foot. (3) 20 EN How to Choose Your Pattern To select a stitch, simply turn the pattern selector dial. The pattern selector dial may be turned in either direction. For straight stitch, select pattern " " or " " with the pattern selector dial. Adjust the stitch length with the stitch length dial. For zigzag stitch, select pattern " " with the pattern selector dial. Adjust the stitch length and stitch width according to the fabric being used. To obtain the other patterns, turn the stitch length dial to "S1" or "S2", select the pattern desired with pattern selector dial, and adjust the stitch width with the stitch width dial. Cadran de sélection de motifs EN Stitch Width Dial & Stitch Length Dial Function of stitch width dial (Model 3229) The maximum zigzag stitch width for zigzag stitching is 5mm; however, the width can be reduced on any patterns. The width increases as you move zigzag dial from "0" - "5". (1) The stitch width dial is also the control for the straight stitch infinite needle position. "0" is center needle position , "5" is full right. Function of stitch length dial while zig-zag stitching Set the pattern selector dial to " ". (3) Function of stitch length dial for when straight stitching For straight stitch sewing, turn the pattern selector dial to the straight stitch setting. Turn the stitch length dial, and the length of the individual stitches will decrease as the dial approached "0". The length of the individual stitches will increase as the dial approaches "4". Generally speaking, use a longer stitch length when sewing heavier weight fabrics or when using a thicker needle or thread. Use a shorter stitch length when sewing lighter weight fabrics or when using a finer needle or thread. [. . . ] Loosen the needle clamp screw and tighten again after inserting the new needle. The flat side of the shaft should be towards the back. C D A B Attention: Turn power switch to off ("O") before inserting or removing the needle. L'aiguille est épointée 49 EN Changing the Bulb Disconnect the machine from the power supply by removing the plug from the electrical socket! [. . . ]