User manual SITECOM WL-114 QIG

[. . . ] If no cable was supplied with your modem, use a standard network cable. Connect the power supply adapter to the broadband router. Use only the adapter supplied with the router. Check the LEDs: · The M1 LED should turn on and after a few seconds it should start BLINKING · The M2 LED should turn OFF, if this light stays on this usually indicates a hardware problem, in this case please contact Sitecom support. [. . . ] The PC configuration is now completed. 4 Windows XP · In the Taskbar, click on the Start button and select - Settings - Control Panel - Internet options. · Select the tab Connections and click the Setup. . . · When the New Connection Wizard starts, click on Next. · Select Connect to internet and click on Next. · Select Set up my connection manually and click on Next. · Select Connect using a broadband connection that is always on and click on Next. · Click on Finish to close the Wizard. · In the Taskbar, click on the Start button and select - Settings - Control Panel - Internet options. · Select the Connections tab and click on the LAN Settings button. · Check carefully that none of the boxes in the Local Area Network (LAN) Settings window are checked. The PC configuration is now completed. Router setup Manual configuration - Internet access 1 Ensure you have TCP/IP settings on your PC, as described above. Do not forget to restart your PC after you have finished. In the Address field, enter the following: http://192. 168. 123. 254 3 Login with the username admin and password admin. The start up window will now be displayed. The Setup wizard will now be displayed; check that the modem is connected and click on Next. 5 6 Select your country from the Country list. 7 From Service, select your internet provider. Click Next. 8 Depending on the chosen provider, you may need to enter your user name and password and MAC address or hostname in the following window. Then click on Next. 6 9 Click Reboot to complete the configuration. 10 The configuration is now completed. If your provider does not appear in the list, consult the full manual to find out how you can configure the router for your connection. 11 Click OK to reboot the router and commit the changes. 12 If you are using a PPTP or PPPoE connection please click Connect in the following window. 13 The router will now connect to the Internet. 7 Wireless settings To change the settings of your wireless network please follow the steps below: · Start your web browser. In the Address field, enter the following: http://192. 168. 123. 254 · Login with the username admin and password admin. · Go to Basic settings->Wireless · Change the settings according to your wishes. · Network ID (SSID): The SSID is an unique ID used by Access Point and stations to identify a wireless LAN. [. . . ] To set up WEP encryption follow these steps: · Select WEP · Select the encryption strength, 64-bit, 128-bit, or 256 -bit. The higher the bit count, the stronger the encryption. · Enter the key you wish to use for encryption in the WEP Key 1 text field. See the follow table for valid WEP key formats: 64 bit 128 bit 256 bit hexadecimal hexadecimal hexadecimal 10 characters 26 characters 58 characters A- F & 0 -9 A- F & 0 -9 A- F & 0 -9 · Click Save to save the changes. [. . . ]