User manual SKIL 2100DAF

[. . . ] WARNING careful in handling, may Dropping or banging the device may result in impaired function or future inaccurate readings. Optimal operation of the measuring tool is possible only when the operating instructions and information are read completely, and the instructions contained therein are strictly followed. [. . . ] The displayed reading corresponds with the internal angle w between the base leg and the fold-out leg. The reading is indicated on the display until the legs are moved in relation to each other. The reading remains unchanged (even when the legs are moved in relation to each other) until the HOLD button 6 is pressed again. tRANSFERRING ANGLE TO MITER ANGLES (Fig. 4) Position the measuring tool with the fold-out leg 1 or with base leg 3 against the angle you want to measure. Adjust the required angle with the other leg and project the angle onto the workpiece. When directly projecting a measured angle onto a workpiece, pay attention that the foldout leg 1 and base leg 3 don't move. After pressing the HOLD button 6, which stores the measured angle, the user can now activate the MTR (miter) button 5. By pressing the MTR button 5, the Angle Finder is taking the measured angle and converting it to the correct Miter Cut Angle. This measurement is what you need to set your miter saw in order to create the correct cut. [. . . ] SELLER'S SOLE OBLIGATION AND YOUR EXCLUSIVE REMEDY under this Limited Warranty and, to the extent permitted by law, any warranty or condition implied by law, shall be the repair or replacement of parts, without charge, which are defective in material or workmanship and which have not been misused, carelessly handled, or misrepaired by persons other than Seller or Authorized Service Station. To make a claim under this Limited Warranty, you must return the complete portable power tool product, transportation prepaid, to any SKIL Factory Service Center or Authorized Service Station. [. . . ]