User manual SKIL 2255

[. . . ] cluttered or dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. Keep children and bystanders away while operating a power tool. [. . . ] Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. If battery case is cracked or otherwise damaged, do not insert into charger. Other types of batteries may burst causing personal injury and damage. Charge battery pack in temperatures above +32 degrees F (0 degrees C) and below +113 degrees F (45 degrees C). Store tool and battery pack in locations where temperatures will not exceed 120 degrees F (49 degrees C). This is important to prevent serious damage to the battery cells. If liquid comes in contact with skin, wash quickly with soap and water. If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging battery pack. The charger and battery pack heat during charging. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. WARNING position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Disconnect battery pack from tool or place the switch in the locked or off Chuck size 3/8" Maximum Capacities Screw sizes #8 x 3" Mild metal 3/8" Hard wood 3/8" Soft wood 13/16" Battery pack 96BAT Charger SC7218 Voltage rating (all models) 120 V 60 Hz WARNING from tool before making any assembly , adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Rotate the chuck sleeve counterDisconnect battery pack clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Do not use the power of the drill while grasping chuck to loosen or tighten bit. Open the chuck all the way, remove left-hand thread screw inside chuck by turning it clockwise (Fig. Insert the short arm of a 3/8" hex key wrench and close jaws on flats of wrench. Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle. INSTALLING CHUCK Always keep the spindle threads, the threads of the chuck and securing screw free of debris. [. . . ] RUNNING NUTS AND BOLTS Variable speed control must be used with caution for driving nuts and bolts with socket set attach ments. The technique is to start slowly, increasing speed as the nut or bolt runs If this procedure is not followed, the tool will have a tendency to torque or twist in your hands when the nut or bolt seats. Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. we recommend that all tool service be performed by a Skil Factory Service Center or Authorized Skil Service Station. [. . . ]