User manual SKIL 2362

[. . . ] In all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Failure to follow all instructions listed below may Keep work area clean and well lit. cluttered or dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] This is important to prevent serious damage to the battery cells. If battery case is cracked or otherwise damaged, do not insert into charger. LITHIUM-ION BATTERIES If equipped with a lithium-ion battery, the battery must be collected, recycled or disposed of in an environmentally sound manner. Program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alterative to placing used Li-ion batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Li-ion battery recycling and disposal bans/restrictions in your area, or return your batteries to a Skil/Bosch/Dremel Service Center for recycling. Robert Bosch Tool Corporation's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. BATTERY REMOVAL INSTRUCTIONS Run motor until battery is completely discharged before attempting to remove battery from your tool. Wrap heavy insulating tape around battery terminals or enclose in a sealable plastic bag to prevent possible shorting. Dispose of battery through your local waste removal authority or a Skil Service Center. Remove the seven (7) housing screws with a flat blade screwdriver. Remove housing cover by lifting upward from front end of tool. CAUTION completely discharged before attempting to remove battery from your tool. Dispose of battery through your local waste removal authority or a Skil Service Center. Loosen the nut with a large wrench in direction of arrow (A) and completely unthread nut. Remove head assembly and nut from the tool. Pull and remove metal front end in direction of arrow (B) to expose and remove the two T6 torx head screws. Remove housing cover by lifting upward from front end of tool. Wrap heavy insulating tape around battery IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. Rotational speed, at no load Per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Li-ion RBRC seal Zero speed, zero torque. [. . . ] First, break the fastener loose in the (manual mode), if necessary. once the fastener has "broken loose" it will start to unthread. Be careful that you do not allow a fastener to spin freely once it is no longer engaged with the other threaded part as it may be thrown out of the accessory. Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. [. . . ]