User manual SKIL 2466

[. . . ] Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. If operating the power tool in damp locations is unavoidable a Ground Fault Circuit Interrupter (GFCI) must be used to supply the power to your tool. GFCI and personal protection devices like electrician's rubber gloves and footwear will further enhance your personal safety. [. . . ] WARNING tool or charger, keep them away from metal objects. For example, to protect terminals from shorting DO NOT place batteries in a tool box or pocket with nails, screws, keys, etc. WARNING when batteries are not in Tool or charger, always place protective cap onto end of battery pack. WARNING semble the battery or remove any component projecting from the battery terminals. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. NICKEL-CADMIUM BATTERIES If equipped with a nickel-cadmium battery, the battery must be collected, recycled or disposed of in an environmentally sound manner. "The EPA certified RBRC Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates Robert Bosch Tool Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alterative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling and disposal bans/restrictions in your area, or return your batteries to a Skil/Bosch/Dremel Service Center for recycling. Robert Bosch Tool Corporation's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. IMPORTANT: Some of the following symbols may be used on your tool. * BATTERY CHARGED CONDITION INDICATOR The battery is equipped with a charged condition indicator (Fig. The indicator lights show the charged condition of the battery during the working process. by pressing the battery fuel indicator button , the charged condition can be checked. Note: to check charge level, the battery must be in the tool. When all three lights are illuminated, this indicates the battery pack is fully charged. When only two lights illuminate, this indicates the battery pack is partially charged. When only one light illuminates, this indicates the battery pack is slightly charged. When no lights illuminate, this indicates the battery pack is completely discharged. DRILL BIT AND SCREW STORAGE COMPARTMENT Your tool is equipped with a handy bit and screw storage compartment in the housing of your tool (Fig. To close, lower lid until it locks in place. * DRILL BIT STORAGE COMPARTMENT AND QUICK REFERENCE GAUGE Your tool may be equipped with a bit storage compartment and quick reference gauge located on top of your tool. [. . . ] Operate the brush with the lightest pressure so only the tips of the wire come in contact with the work. If heavier pressures are used, the wires will be overstressed, resulting in a wiping action; and if this is continued, the life of the brush will be shortened due to wire fatigue. Apply the brush to the work in such a way that as much of the brush face as possible is in full contact with the work. RUNNING NUTS AND BOLTS Variable speed control must be used with caution for driving nuts and bolts with socket set attachments. [. . . ]