User manual SKIL 2866

[. . . ] Failure to follow all instructions listed below may All of the warnings listed below refers to your mains-operated (corded) power tool or batteryoperated (cordless) power tool. cluttered or dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] This lever was designed for changing rotation of the chuck, and for locking the trigger in an "OFF" position to help prevent accidental starts and accidental battery discharge. FORWARD/REVERSE INDICATOR LIGHTS Your tool is equipped with lights which indicates the rotation of the chuck. For forward rotation, (with chuck pointed away from you) move the forward/reversing lever to the far left and the green indicator will light up when the trigger is activated. For reverse rotation move the forward /reversing lever to the far right and the red indicator light will light up when the trigger is activated. To activate trigger lock move the forward/ reversing lever to the center off position. Do not change direction of rotation until the tool comes to a complete stop. Shifting during rotation of the chuck can cause damage to the tool. INSERTING BIT For small bits, open jaws enough to insert the bit up to the flutes. for large bits , insert the bit as far as it will go. Center the bit as you close the jaws by hand. This positions the bit properly, giving maximum contact between the chuck jaws and the bit shank. To tighten, hold the chuck collar firmly with one hand and securely tighten the chuck sleeve with the other hand (Fig. Open the chuck all the way, remove left-hand thread screw inside chuck by turning it clockwise. Insert the short arm of a 3/8" hex key wrench and close jaws on flats of wrench. Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle (Fig. The drill " " position will lock up the clutch to permit drilling and driving for heavyduty work. bRAKE When the trigger switch is released it activates the brake to stop the chuck quickly. This is especially useful in the repetitive driving and removal of screws. INSTALLING CHUCK Always keep the spindle threads, the threads of the chuck and securing screw free of debris. to install a chuck , reverse "removing the chuck" procedure. RELEASING AND INSERTING BATTERY PACK Release battery pack from tool by pressing on both sides of the battery release tabs and pull downwards. Before inserting battery pack, remove protective cap from battery pack. [. . . ] The technique is to start slowly, increasing speed as the nut or bolt runs If this procedure is not followed, the tool will have a tendency to torque or twist in your hands when the nut or bolt seats. Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. we recommend that all tool service be performed by a Skil Factory Service Center or Authorized Skil Service Station. SERVICEMEN: Disconnect tool and/or charger from power source before servicing. [. . . ]