User manual SKIL 3300MS

[. . . ] Because cut material may cause the stand to become unbalanced, always be sure the material is supported properly. Also, if the piece being cut is placed far beyond the work support, stand legs on the opposite side may suddenly be lifted up due to weight imbalance. To prevent this from occurring, hold the opposite side firmly before cutting. Also remember to occasionally check the stand and make sure it is still tight. [. . . ] Secure in place using a flat washer (4), lock washer (5), and nut (6). Repeat steps 1 through 4 to install second bracket to the other side of the saw. After making sure both brackets are parallel to each other, finger tighten all four nuts to hold in position. Attaching saws with three mounting holes to saw mounting brackets (Such as the Skil 3800 Miter Saw): See Figures 6 - 7. Attach support bar (7) to rear carriage bolt of both mounting brackets, as shown in figure 6. Secure in place using a flat washer (8), lock washer (9), and nut (10). Unplug the saw and lock the saw arm in the down position. Lift and lower the saw down onto the brackets, feeding the front carriage bolts through the front mounting holes of the saw. Carriage bolt (11) through the support bar (7) and rear mounting hole of the saw. Secure the three bolts using a flat washer (12), lock washer (13), and nut (14). After making sure both brackets are parallel to each other, finger tighten all four nuts to hold in position. Lift the saw and bracket assembly, allowing the assembly to tilt slightly toward your body. While still tilted toward you, hook the front edge of the bracket assembly onto the front rail (1) of the stand, figure 8. To avoid serious personal injury, make sure the curved front edge of the mounting brackets are securely seated over the front rail before seating the other end of the brackets. Failure to do so could cause you to lose control of the saw mounting assembly. Lower the bracket assembly to allow the rear edge of the bracket to seat fully over the rear rail, figure 9. NOTE: Continue to hold the mounting bracket assembly with one hand until both levers are securely locked. Check position and adjust, if necessary, to make sure the weight of the saw is evenly balanced over the rails as shown in figure 9. Ensure the saw is fully seated and locked in position, then securely tighten the four nuts holding the saw to the saw mounting brackets. Lift the saw away from the rear rail of the stand to disengage. With the assembly tilted slightly toward you, lift the front part of the assembly to disengage from the front rail of the stand. The mounting brackets are designed to fit snugly over the stand rails. [. . . ] Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. SERVICE For service or to order replacement parts and accessories for tools with model numbers NOT beginning with "HD" In the United States When servicing, use only identical Skil replacement parts. Use of any other parts may create a hazard or cause product damage. [. . . ]