User manual SKIL 3315

[. . . ] ) symbol listed BELOW and other safety precautions, may result in serious personal injury. cluttered benches and dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] Not use saw and respiratory Use rated 5000/min or greater. if guard doesn't operate smoothly , have it serviced. After changing blade return guard to operating position. Keep hands a safe distance from saw blade. Disconnect saw from power source before servicing or changing blade. Never reach around or in the back of the saw blade Hold or clamp workpiece against base and fence. Never place your hands or arms across the projected saw blade path. With motor OFF, make a Dry-Run to be aware of the blade's reach. After turning saw OFF, keep saw in the down position and wait for blade to stop before removing cutoff pieces or changing settings. To avoid electrical shock, do not expose to rain or use in damp locations. When servicing use only identical replacement parts. To reduce the risk of injury, always use the clamp to support the workpiece when making a compound miter cut. CAUTION lock knob in 45° left or right position. Lock head assembly in the down position. Separate all parts from packing materials and check each one with the parts in Figure 1 to make sure all items are accounted for before discarding any packing material. Never carry the tool by the cord or head assembly power switch handle. Model 3315 Compound Miter Saw is shipped complete in one box. If any parts are missing, do not plug in power cord or turn the switch on until the missing parts are obtained and are installed correctly. Should be no Gap or Overlap when Square is Flipped Over in Dotted Position Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible Draw Light Tracez une ligne délicateon Board Line sur la planche leAlong this Edge long de ce bord. Should beavoirGap or Overlap Il ne doit y no aucun écartement when Square is Flipped Over in ou chevauchement lorsque l'équerre Dotted Position position en tirets. Carefully thread the miter lock knob 1 into the hole 2 located at the front of the miter table (Figure 2). Turn the miter lock knob clockwise to tighten. [. . . ] Otherwise a break-in period will occur that will reduce motor performance and increase brush wear. To avoid accidents always disconnect the tool from the power supply before cleaning or performing any maintenance. The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with compressed air. [. . . ]