User manual SKYMASTER ARF PLUS PRO A10

[. . . ] 1/6. 25 Scale Almost-Ready-To-Fly RC Jet Assembly and operations manual Spesifications Type : T. A. V. S ARF PRO Scale : 1/6. 25th Length : 101, 3": (2552mm) Span : 109, 6": (2784mm) Weight : 40--46 Lbs ( 19--21. 5 Kg) Engine : 2 x 22--36 Lbs (10 --12 Kg) trust Radio : 12 Channel 13--15 servo's The A-10 Warthog by Skymaster Thank you very much for purchasing our Skymaster ARF PRO A-10. Please note that the photos in this instruction manual show certain views from the prototypes. Some modifications and upgrades might have taken place by the release of the model. We have tried to produce a very scale replica of this classic jet. [. . . ] Mark each step. operation of Landing gear and doors. Check all bolts and nuts and secure if needed. Check Remove factory self tapping L/G screws and replace with high quality screws. Photo 17 L/G box is removable. the operation of brake Check Remove and mark servo covers and inspect plywood. Use dremel to clean out some glue and ply to make sure servos will fit well. Photo 18 P-12 Assembly & Operation Manual all items needed to complete wings. Fit 2 L-shape Locate servo brackets to 1 x JR DS8711 servos. servo must be mounted with horns facing up. The horn Aileron must be closest to control surface and furthest away for root. Photo 19 servo horns and centre servo's with TX. Use safety Secure clips on joint. servo's to wing. Secure a line perpendicular to hinge line & mark location of horn Draw Dremel to drill 1. 5mm pilot holes and to mill slot for conUse trol horns. Photo 20 30 minute epoxy to glue control horns Use epoxy cured, insert pushrods and secure safety clips. Mill slot in servo cover and Check secure with 4 x 1mm set screws. Photo 21 INSTALLING SPEEDIF BRAKE FOLLOW FOLLOWING STEPS--OR GLUE 2 HALVES TOGETHER FOR NORMAL OPERATION. 2 x pushrods to JR8711 servos. Take care when bending aileron not to damage the live hinging. Use tape to secure aileron in 90deg position for easy installation of speed brake servo. Photo 22 servo for speed brake function on radio and fasten servo Setup horn. The horn must face the top surface of wing and trailing edge. The servo is installed into aileron. slots for 2 x horn and glue Cut with 30min epoxy. (P21) Photo 23 pushrods and check operation of speed brake. Fit some play in servo wire for operation of aileron. Leave Photo 24 P-13 Assembly & Operation Manual NOTE: Flaps are factory installed on slides utilizing bearings. Please make sure the slides are free of any dirt or glue. The pushrods must be installed centre of each flap for best operation. up flap pushrod. Make pushrod to servo horn (long horns) and secure safety Fit clip. pushrod through hole in trailing edge and fasten Slide servo with 4 screws. Photo 25 the ball links to secure pushrods to flap. The flap Use horn on later models factory installed. On early models please cut slot in flap and glue horn with 30min epoxy. pushrod and insert safety clips. [. . . ] Get into the habit of programming the timer. Weight PSI Power RX TX Speed Timer P-25 Assembly & Operation Manual Take-Off Do some taxi tests before your flight!Make sure you are familiar with all settings and make sure the model track straight on the ground without rudder input. Choose a fine day for the maiden flight. Select take off flap or flight mode 1 and open throttle. [. . . ]