User manual SMART DEVICES EX520 HOOKUP INSTRUCTIONS

[. . . ] If this product is used in countries that have an AC line voltage of 220-240 volts AC then a suitable power pack must be furnished by the customer. Standard connection to telephone wall sockets and phones. Origination of telephone service at the phone company. This number represents the load on the phone line. [. . . ] The Mode LED also flashes amber as the MovieTimeS processes commands. In the event of a system failure, the mode LED flashes red. LINE LEDs The Line LEDs will show green whenever the MovieTimeS is in control of the line. The FACTORY jack on the back of the MovieTimeS must not be used by customer. This jack is used by the factory to load instructions to the internal computer. If program upgrades are available in the future, your machine may be upgraded to the new software by returning it to the factory to load the new operating program. Note: You must delete a message before recording a new message. This is necessary because your new message may be shorter than the old one and the last part of the old message will remain. Deleting the message restores a blank memory box, ready for the new message. 8 Maximizing the capability of the MovieTimeS. This digital answering device has 24 message boxes for show times on 24 screens. If you have a 30 screen complex, often a movie is played in interlock on multiple screens. We suggest you mention the movie once and use a show times box to give the show times for all showings. The available messages and message lengths vary with the Message Table and installed memory, see the Message Table command for more information. After the command is entered, the MovieTimeS plays a steady series of short beeps (ready tones) At any point after the ready tones begin, the user may enter " * " to start the recording. Recording continues until the user enters " # " or the maximum record time for the message is reached. At this point, the MovieTimeS plays a success beep and is ready to receive the next command . The error tone sounds if the user attempts to record a message that is not available in the current Message Table or if the selected message has previously been recorded and not erased. Note: You must delete a message before recording a new message. This is necessary because your new message may be shorter than the old one and the last part of the old message will remain. Deleting the message restores a blank memory box, ready for the new message. Syntax: *5 0 0 1# through *5024# I Record Screen Message #1 - #24 *50 24# * 5 0 3 1 # Record Greeting Message * 5 0 3 2 # Record Movie List Message * 5 0 3 3 # Record Info. Message #3 MESSAGE REVIEW The Message Review commands allow the user to review each of the messages. After the command is entered the requested message plays. After message play completes the user hears the success beep and returns to command mode ready to enter the next command. The user may enter " # " at any point during message review to abort the play back, at which point the user hears the success beep and returns to command mode ready to enter the next command. [. . . ] 15 APPENDIX E CONTACTING SMART CUSTOMER SUPPORT Only contact customer service if you are unable to resolve your problem through the dealer you purchased this unit from, and while you are able to review and make changes to the settings on the MovieTimeS you are experiencing problems with. NOTE: SMART customer service provides support for the MovieTimeS only. If you are experiencing problems with your phone system itself please refer your problem to the correct vendor. Customer service can be reached Monday through Friday at 800-45-SMART from 8:00 to 5:00 EST. APPENDIX F NOTICES & WARRANTY FCC Notice WARNING: This equipment HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL DEVICE PURSUANT TO PART 15 OF FCC RULES. [. . . ]