User manual SMART DEVICES EX525 DATASHEET

[. . . ] If this product is used in countries that have an AC line voltage of 220-240 volts AC then a suitable power pack must be furnished by the customer. Standard connection to telephone wall sockets and phones. Origination of telephone service at the phone company. 117 VAC Modular cable Central Office LED REN Light Emitting Diodes. This number represents the load on the phone line. [. . . ] Not all Central Offices support CPC signaling. If the MovieTimeS does not receive the CPC signal it may take as long as 90 seconds after message play is complete to return to normal operation and calls also ring through even if the calling party has hung up during the message or transfer. REN The MovieTimeS supports an outgoing Ringer Equivalence Number of 5. To identify the REN requirements of your installation look for the REN number listed on each device installed on the line after the MovieTimeS. Add these values together and confirm that the total is less then 5. For example the REN of the MovieTimeS is 0. 6. If you add a telephone to the same line with an REN of 0. 5, the total is a REN of 1. 1. Never add instruments to the line that exceed 5 or the telephone company will get upset with the heavy load on their line. 9 LIGHTS & INDICATORS The MovieTimeS front panel has a multicolored Mode LED and a green Line LED for each available line. MODE LED The Mode LED normally flashes green to indicate normal operation. The Mode LED also flashes amber as the MovieTimeS processes commands. In the event of a system failure, the mode LED flashes red. If the selected message has not been recorded the user hears the error tone and returns to command mode ready to enter the next command. Syntax: *60 01# *60 24# *60 31# *60 32# *60 33# *60 34# *60 35# Review Screen Messages #1 - #24 Review Greeting Message Review Movie List Message Review Info. Message #3 MESSAGE DELETE A current message must be deleted before recording a new message. This will remove any remnants of the old message, if the new one is shorter. Each Message Delete command allows the user to delete any one of the messages. While the message is being deleted the user will hear the system busy signal for a period of time followed by the success beep, returning to command mode ready to enter the next command. If the user deletes the primary message for the current Answer Mode, the unit reverts to Bypass Mode after the call is complete. Syntax: *70 01# *70 24# *70 31# *70 32# *70 33# *70 34# *70 35# Delete Screen Messages #1 - #24 Delete Greeting Message Delete Movie List Message Delete Info. Message #3 SET RING Set Rings command sets the number of rings that the unit answers on. Valid numbers of rings range from 01 to 15. If a valid number of rings is entered the user hears the success beep and returns to command mode ready to enter the next command. [. . . ] To remove the machine from the plate, push the machine up until it is free from the tabs. Make sure no wires are trapped behind the machine. Mounting plate and screws The machine should face up with the LED's showing the line status. 18 APPENDIX E CONTACTING SMART CUSTOMER SUPPORT Only contact customer service if you are unable to resolve your problem through the dealer you purchased this unit from, and while you are able to review and make changes to the settings on the MovieTimeS you are experiencing problems with. NOTE: SMART customer service provides support for the MovieTimeS only. If you are experiencing problems with your phone system itself please refer your problem to the correct vendor. Customer service can be reached Monday through Friday at 800-45-SMART from 8:00 to 5:00 EST. APPENDIX F NOTICES & WARRANTY FCC Notice WARNING: This equipment HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL DEVICE PURSUANT TO PART 15 OF FCC RULES. [. . . ]