User manual SMART DEVICES HF102 INSTALLATION

[. . . ] All returns must be shipped freight prepaid by the dealer. Equipment returned without a factory RA (Return Authorization) will be refused. HF102 10 Channel Cinema Booth Monitor USER'S GUIDE +ONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 8 SMART products are designed to deliver unsurpassed quality in workmanship and performance. The following information gives detailed instructions on the installation and operation of the SMART HF102 Cinema Booth Monitor. We strongly encourage new owners of the HF102 to thoroughly read this entire manual before placing their new SMART product into service. This will ensure that the HF102 will be operated properly to give the superior performance that it was designed to deliver. 4 HF102 10 CHANNEL BOOTH MONITOR INTRODUCTION The HF102 is a 10 channel booth monitor that monitors both sound processor and amplifier outputs while incorporating a number of advanced features: · 10 Channels. The HF102's 20 inputs are split between processor and amplifier banks of 10 each. The banks are selectable using the MODE button located on the front panel. To avoid ground loop hum, the HF102 has balanced inputs on all channels. Connecting a processor with a THX Standard output is quick and easy. Both the processor and amplifier banks provide Biamp and Triamp monitoring for the Left, Center and Right channels. The multiple pushbutton interface allows the user to add in all ten channels on either bank to the output amplifier. For Biamped Left, Center and Right channels, use the "Lo" inputs for the low frequency band, and the "Hi" Inputs for the higher frequency band. For Triamped Left, Center, and Right channels, use the "Lo" for low, "Mid" for middle and "Hi" for high frequency bands. Set the processor and amplifier gain trimpots for the desired level. After the processor and amplifiers have been set up and calibrated for optimal presentation, run pink noise through the processor set at the cal point volume level. Select processor mode and a channel with pink noise on the monitor. Using a tuning wand or equivalent, adjust the P Gain Trimpot (located on the front of the monitor unit) until the third USER'S GUIDE 7 Signal Presence LED just comes on. Change to amplifier mode on the monitor, and repeat using the A Gain Trimpot. The monitor volume knob may be turned down during this adjustment. If the monitor sound level is not high enough, these pots may be adjusted clockwise for additional gain. The HF102 provides a 1/4"/6. 3mm external speaker jack on the rear of the unit. [. . . ] The HF102 provides a 1/4"/6. 3mm external speaker jack on the rear of the unit. Wire a 4 or 8 ohm speaker to a mono 1/4" phono jack and insert in the jack labeled EXTERNAL SPEAKER. When the external speaker jack is used, the built-in speaker is disconnected. 8 HF102 10 CHANNEL BOOTH MONITOR OPERATION Power is applied to the unit when the red POWER LED on the front panel is lit. The 1/ 4" mono HEADPHONE jack allows for better listening in a noisy booth environment. [. . . ]