User manual SMART DEVICES MT4-16 5-1-04

[. . . ] MT4-16 MovieTimeSTM Digital Phone Announcer Installation and Operation Manual 5-1-04 1 Glossary of terms used in this manual. TELCO KSU/PBX 117 VAC Telephone company line that comes to your building. A telephone system that has multiple lines. May be mechanical buttons or electronic. The wall power pack furnished in North America is a 12 VDC 500 mA supply. [. . . ] You may elect to use these empty boxes for movie reviews of the current movies. For example: In the Movie List box say "For Titanic press 2, for a review of this movie by the leading film critics, press 23. " Then record a review in box 23. SET UP / OPERATION FACTORY RESET The MovieTimeS can be reset to the factory default settings by holding the mode button down while power is applied. This erases all messages and brings the system to a fresh state which provides a good starting point for system configuration. See appendix C for a full listing of the default values. SEIZING CONTROL The MovieTimeS is setup by seizing control of the unit to enter Command Mode and then entering a series of two digit command codes to manipulate settings and record messages. Seizing control of a unit can be done by one of two ways: · Local - Through the use of a phone that is installed in the PGM jack of the MovieTimeS. Control is seized by picking up the handset of the local phone, listening for a Beep tone and then entering # * * followed by the Master Password (factory default = 1 2 3 4"). After entering # * * followed by the Master Password, the dial tone may change to a busy tone or start ringing, ignore it. Within 5 seconds of entering the Master Password the MovieTimeS seizes the line and plays a triple beep indicating it has been placed in Command Mode. · Remote -The unit answers and plays the Greeting message after a predetermined number of rings (factory default = 1). If the message is not present, the unit answers and plays a single beep. After the unit answers you may proceed by entering # * * followed by the Master Password (factory default = "ll 2 3 4"). Within 5 seconds of entering the Master Password the MovieTimeS seizes the line and plays a triple beep indicating it has been placed in Command Mode. Failure to enter a password in 20 seconds, or after the end of the message results in a disconnection. NOTE: When control has been seized from the Remote, a busy signal is heard on the Local telephone you are using. 9 Once the unit is in Command Mode the user may start entering commands. All commands start by entering "*" and end by entering a "#"". After each valid command, a single success beep sounds. Invalid entries are indicated by an double beep error tone. NOTE: Seizing control causes any calls in progress on the other line to be disconnected. MESSAGE RECORD The Message Record commands allow the user to record one of the available messages. This will remove any remnants of the old message, if the new one is shorter. Each Message Delete command allows the user to delete any one of the messages. [. . . ] THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THIS EQUIPMENT IS OPERATED IN A COMMERCIAL ENVIRONMENT. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential environment is likely to cause harmful interference in which case the user will be required to correct the interference AT HIS/HER OWN EXPENSE. LIMITED WARRANTY SMART devices, Inc. warrants that all equipment sold is free from defects in material and workmanship at the time of purchase. [. . . ]