User manual SMART-CLIP SMART-CLIP

[. . . ] E/G indicator will light green and go off, the phone will switch off (some models will automatically turn on then). E/G will light green on success or red on error. Successful unlock resets User Code to 1234, Security Code to 000000 SENDO SND2XX/SND3XX/SND5XX/SND6XX/SND8XX UNLOCKING PROCEDURE: Power off the phone. Connect clip to the phone using RJ45 cable (pinouts below) Press UNLOCK button Press Power button on the phone within 5 seconds after you press UNLOCK button on a clip. [. . . ] To improve clip to phone connectivity: 1. Remove 4 front-panel screws Take PCB out of the box carefully Solder LPT and USB ports to ground (reference picture below) Assemble clip 2004 © Copyright GsmServer Team FAQ Does Smart-Clip need to be activated?This product is developed in a ready to go fashion. However, it may happen that by the time you have Smart-Clip there is a newer version of firmware available for it. You can update your clip easily by going to http://www. smart-clip. com/upgrade. php and running "Smart-Clip Online Updater". Where do I get login/password for product update?Smart-Clip update system is organized in such way that you do not need to register for update. Every owner can go to support page and connect his/her clip using "Smart-Clip Online Updater". How do I know the version of my Smart-Clip?You can go to upgrade zone on our site and connect smart-clip using . When the program asks you if you want to install and run "Smart-Clip Online Updater" answer "yes". Update program will inform you about your product version. Rather it is a platform for ongoing solutions constantly developed by GsmServer team. Similar to Griffin and Twister Smart-Clip stays efficient all the time by means of available updates. LPT port is a physical channel for on-line updates. Do I need to configure my LPT port for Smart-Clip update?Normally all LPT ports are set by default to operate in Smart-Clip friendly way. However, if your LPT configurations have been changed you should know that 2004 © Copyright GsmServer Team bidirectional modes (EPP, ECP) are required for Smart-Clip update to operate properly. Please go to page http://www. smart-clip. com/support. html for instructions. "Smart-Clip Online Updater" doesn't show in my browser. In order to install and run "Smart-Clip Online Updater" you need to use Internet Explorer 5 and later IE versions. Your browser should be configured to allow Active X element use. [. . . ] I'm having problems when using Windows XP/2000. . . In order to successfully update your clip (or use SCReader. exe) under Windows XP you need to enter the system as an Administrator (or as a user with administrative rights). What should I do if Smart-Clip doesn't unlock a phone?First of all, make sure the phone model you are trying to unlock is in the list of supported models. [. . . ]