User manual SMC NETWORKS SMC7004VBR

[. . . ] BarricadeTM Broadband Router Broadband Router with 4-Port Switch N N N N N N Multi-user Internet access via single user account EZ 3-Click Installation Wizard Configurable Parental Control Stateful Packet Inspection and DoS support Supports a Wide Variety of Internet Applications Virtual Private Network using PPTP, L2TP, IPSec pass-through User Guide SMC7004VBR BarricadeTM Broadband Router User Guide From SMC's Barricade line of Broadband Routers 38 Tesla Irvine, CA 92618 Phone: (949) 679-8000 May 2002 Part Number: 150200009800A Revision Number: R01 Copyright Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. [. . . ] Check the Status page Information section to confirm that the upgrade process was successful. 4-33 ADVANCED SETUP Reset Click "Apply" to reset the Barricade. The reset will be complete when the power LED stops blinking. Note: If you use the Reset button on the rear panel, the Barricade performs a power reset. If the button is held depressed for over 5 seconds, all the LEDs will illuminate and the factory settings will be restored. 4-34 CONFIGURING THE BARRICADE Status The Status screen displays WAN/LAN connection status, firmware, and hardware version numbers, illegal attempts to access your network, as well as information on DHCP clients connected to your network. 4-35 ADVANCED SETUP The following items are included on this screen: Section INTERNET GATEWAY INFORMATION Description Displays WAN connection type and status. Displays system IP settings, as well as DHCP and Firewall status. Displays the number of attached clients, the firmware versions, the physical MAC address for each media interface, as well as the hardware version and serial number. Displays illegal attempts to access your network. Click on this button to save a security log file. Click on this button to delete the access log. Click on this button to refresh the screen. Displays information on all DHCP clients on your network. Click on this button to confirm Dynamic settings. Click on this button to refresh Dynamic settings. Security Log Save Clear Refresh DHCP Client Log Release Renew 4-36 CHAPTER 5 CONFIGURING CLIENT TCP/IP If you have not previously installed the TCP/IP protocols on your client PCs, refer to the following section. If you need information on how to configure a TCP/IP address on a PC, refer to "Setting Up TCP/IP to Work with the Barricade" on page 5-5. Installing TCP/IP Windows 95/98/ME 1. Click "Start/Settings/Control Panel. " 2. Double-click the Network icon and select the "Configuration" tab in the Network window. Double-click "Protocol. " 5-1 INSTALLING TCP/IP 5. Select "Microsoft" in the manufacturers list. Select "TCP/IP" in the Network Protocols list. Click the "OK" button to return to the Network window. 6. The TCP/IP protocol will be listed in the Network window. Click "OK" to complete the installation procedure and restart your PC to enable the TCP/IP protocols. [. . . ] Be sure that the network interface on the attached device is configured for the proper communication speed and duplex mode. Check the adapter on the attached device and cable connections for possible defects. Replace any defective adapter or cable if necessary. Action · Network Connection Problems Cannot Ping the Barricade from the attached LAN, or the Barricade cannot Ping any device on the attached LAN · Verify that the IP addresses are properly configured. [. . . ]