Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SMC EZ1016DT V.5. We hope that this SMC EZ1016DT V.5 user guide will be useful to you.
Lastmanuals help download the user guide SMC EZ1016DT V.5.
Detailed instructions for use are in the User's Guide.
[. . . ] PCs can be connected to these ports with straight-through cable. Each port supports AutoNegotiation, so the optimum communication mode (half or full duplex) and data rate (10 Mbps or 100 Mbps) are selected automatically. Port 16 has an associated toggle switch so that you can change it from a crossover port to a straight-through daisy-chain port. [. . . ] · The status LEDs should be clearly visible. · There should be adequate space (approximately two inches) on all sides for proper air flow. Before rack mounting the switch, pay particular attention to the following factors: · Temperature: Since the temperature within a rack assembly may be higher than the ambient room temperature, check that the rackenvironment temperature is within the specified operating temperature range. · Mechanical Loading: Do not place any equipment on top of a rack-mounted switch. · Circuit Overloading: Be sure that the supply circuit to the rack assembly is not overloaded. · Grounding: Rack-mounted equipment should be properly grounded. Particular attention should be given to supply connections other than direct connections to the mains.
High-Speed Switch Links
TROUBLESHOOTING
1. Symptom
Power LED does not light after power on.
Probable Causes
Power outlet or power cord may be defective.
Port and Switch Status LEDs Condition Status
Switch is receiving power.
Possible Solutions
· Check for loose connections. · Check the power outlet by using it for another device. · Replace the power cord.
Indicates that the connection between port and attached device is valid. Flashing Green Indicates that the switch is transmitting or receiving data. Green Indicates that the port is operating at 100 Mbps. G r een Indicates that the port is operating in full-duplex mode.
2. Symptom
Link LED does not light after connection is made.
Probable Causes
Switch port, network card or cable may be defective.
Possible Solutions
· Check that the switch and attached device are both powered on. [. . . ] Each wire pair is identified by two different colors. For example, one wire might be green and the other, green with a white stripe. Each wire pair must be attached to the RJ-45 connector in a specific orientation. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SMC EZ1016DT V.5
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SMC EZ1016DT V.5 will begin.
