User manual SMC 7904BRB2

[. . . ] Router with built-in ADSL2/2+ Modem From SMC's line of award-winning connectivity solutions 38 Tesla Irvine, CA 92618 Phone: (949) 679-8000 August 2006 R. 01 F/W 0. 11 Information furnished is believed to be accurate and reliable. However, no responsibility is assumed by our company for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of our company. We reserve the right to change specifications at any time without notice. [. . . ] WAN subnet mask (only displayed if you have static IP). WAN gateway (only displayed if you have static IP). 4-14 SETUP WIZARD Parameter DNS Server Description The IP address of the DNS server. If the DNS address field was left blank in previous steps the address will be displayed as 0. 0. 0. 0. The password (hidden). ISP Parameters Username Password If the parameters are correct, click FINISH to save these settings. Go to "Troubleshooting" on page A-1 if you cannot make a connection to the Internet. 4-15 CONFIGURING THE BARRICADETM Configuration parameters There are 13 main menu items located on the left side of the screen. Each main menu item is described in the following table. Menu System Description Sets the local time zone, the password for administrator access, and the IP address of a PC that will be allowed to manage the Barricade remotely. Configures the Internet connection settings. Sets the TCP/IP configuration for the Barricade LAN interface and DHCP clients. Configures Address Mapping, virtual server and special applications. Sets the routing parameters and displays the current routing table. Configures a variety of security and specialized functions including: Access Control, URL blocking, Internet access control scheduling, intruder detection, and DMZ. Community string and trap server settings. Enable/disable the Universal Plug and Play function. Allows you to optimize your network traffic. Sets the ADSL operation type and shows the ADSL status. WAN LAN NAT Routing Firewall SNMP UPnP QoS ADSL 4-16 CONFIGURATION PARAMETERS Menu DDNS Tools Description Configures Dynamic DNS function. Contains options to backup & restore the current configuration, restore all configuration settings to the factory defaults, update system firmware, or reset the system. Provides WAN connection type and status, firmware and hardware version numbers, system IP settings, as well as DHCP, NAT, and firewall information. Displays the number of attached clients, the firmware versions, the physical MAC address for each media interface, and the hardware version and serial number. Shows the security and DHCP client log. Status 4-17 CONFIGURING THE BARRICADETM SYSTEM Time Settings Select your local time zone from the drop down menu. This information is used for log entries and client filtering. For accurate timing of log entries and system events, you need to set the time zone. Select your time zone from the drop down menu. If daylight savings is used in your area, check the box to enable the function, and select the start/end dates. If you want to automatically synchronize the ADSL router with a public time server, check the box to Enable Automatic Time Server Maintenance. [. . . ] However, if you manually configure IP addresses on the LAN, verify that the same network address (network component of the IP address) and subnet mask are used for both the Barricade and any attached LAN devices. Be sure the device you want to ping (or from which you are pinging) has been configured for TCP/IP. · A-2 TROUBLESHOOTING Troubleshooting Chart Symptom Action Management Problems Cannot connect using the web browser · · Be sure to have configured the Barricade with a valid IP address, subnet mask, and default gateway. Check that you have a valid network connection to the Barricade and that the port you are using has not been disabled. Check the network cabling between the management station and the Barricade. [. . . ]