User manual SMC WPCI-GM

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. [. . . ] Profile function is based on the needs to set up the most linkable AP in order to record the system configuration and to set up the authentication security. The function of each session is shown below - 13 - 4-2 Authentication & Security As shown in picture . When the Encryption feature is enabled, the other setups are same as the said WEP setting. 1. Authentication Type: There are three type of authentication modes supported by RaConfig. They are open, Shared, WPA-PSK and WPA system. 802. 1x Setting: It will display to set when user use radius server to authenticate client certificate for WPA authentication mode. The detail operation will explain in section 5-6 Configure connection with WPA by 802. 1x setting 3. Encryption Type: For open and shared authentication mode, the selection of encryption type are None and WEP. For WPA, WPA2, WPA-PSK and WPA2-PSK authentication mode, the encryption type supports both TKIP and AES. WPA Pre-shared Key: This is the shared secret between AP and STA. For WPA-PSK and WPA2-PSK authentication mode, this field must be filled with character longer than 8 and less than 32 length. WEP Key: Only valid when using WEP encryption algorithm. The key must matched AP There are several formats to enter the keys. Hexadecimal40bits10 Hex characters. - 14 - key. ii. iv. Hexadecimal128bits32Hex characters. ASCII128bits13 ASCII characters. 4-2-1 802. 1x Setting 802. 1x is a authentication for WPAand WPA2certificate to server. PEAP: Protect Extensible Authentication Protocol. PEAP transport securely authentication data by using tunneling between PEAP clients and an authentication server. PEAP can authenticate wireless LAN clients using only server-side certificates, thus simplifying the implementation and administration of a secure wireless LAN. TLSSmart Card: Transport Layer Security. Provides for certificate-based and - 15 - mutual authentication of the client and the network. It relies on client-side and server-side certificates to perform authentication and can be used to dynamically generate user-based and session-based WEP keys to secure subsequent iii. [. . . ] Off: Always send frame without protection. 3. TX Rate: Manually force the Transmit using selected rate. CCX2. 0: support Cisco Compatible Extensions function: i. Enable Radio Measurement: can channel measurement every 0~2000 milliseconds. [. . . ]