User manual SMEG 7520GR

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] When the programme you selected starts its operation the lamp above the start/pause button will start lighting. When you wish to put the selected programme on pause press the start/pause button once. In order to restart the programme from the point it was put on pause at you will have to press the start/pause button once again. Starting the program Adjust the programme button to a programme you wish to select. If the programme you selected is a wash programme the wash operation lamp will flash. If the programme you selected is a rinse/spin or drain programme the lamps indicating the related selection will flash. Start the selected programme by pressing the start/pause button. When you start the programme by pressing the start/pause button the lamps will light up indicating that the start/pause button is active and the wash operation is in progress. In the event power is cut off during the wash operation the door lock mechanism will release its hold after two minutes. If there is water in the machine do not open the door or the water will pour out. If you wish to take out your laundry you can do so by draining the water inside the machine following the instructions explained in the section "cleaning the pump filter" on pages 20 and 21. Child lock Your machine is equipped with a child lock in order to prevent a programme's operation from being affected by a push on a button during a wash operation. The child lock will become active after the first and second function buttons on the control panel are pressed at the same time and for longer than three seconds. You can notice the activation of the child lock by checking out the programme wash, rinse and spin lamps which will flash for two seconds. In order to take out the drawer: Pull the drawer to its end (DIAGRAM-1). Keep pulling by pressing on the siphon lid inside the drawer pulled to its end, and remove the drawer from its place (DIAGRAM-2). Wash it up with water with the help of an old toothbrush. Collect the residues inside the drawer slot without letting them drop into the machine. After thoroughly drying the drawer put it back in its place reversing the removal procedure. DIAGRAM-1 21 DIAGRAM-2 SIPHON PLUG Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. Siphon plug THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 26 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]