User manual SMEG ALFA31XE

[. . . ] THE ELECTRICAL SYSTEM MUST BE GROUNDED ACCORDANCE WITH ESTABLISHED SAFETY REGULATIONS. IN WHEN HOOKING UP TO THE MAINS WITH A PLUG AND SOCKET, MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS. VENTILATION OPENINGS AND HEAT IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE POWER SUPPLY AND CONTACT THE NEAREST TECHNICAL ASSISTANCE CENTRE. [. . . ] Now press or hold down START to increment the hour display. Once the current hour has been set, press STOP to set the minutes and increment them as before by pressing the START button. When the correct time is set, press the STOP button and the display will stop flashing. 24 Instructions for the user 4. 3 Program selection This oven has 10 different cooking programs, including: 5 preset programs for fan-mode cooking (P1 to P5); 4 user-editable programs for fan-mode cooking (P6 to P9), 1 "easy" user-editable program for fan-mode cooking. The following table shows the parameters for each program. Uprh preheating temperature 170 °C 175 °C 180 °C 190 °C 200 °C Editable Editable Editable Editable Same as edited Ut°C Ut °C cooking temperature 170 °C 175 °C 180 °C 190 °C 200 °C Editable Editable Editable Editable Editable U Ct cooking time 20 minutes 20 minutes 20 minutes 20 minutes 20 minutes Editable Editable Editable Editable Editable P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 4. 4 Fan mode cooking Use the knob to select one of the preset programs (P1 ­ P5). The display shows the parameters of the selected program (tc = cooking time; temperature in degrees Centigrade and program number, e. g. Press START to confirm the start of the program. The program starts, performing the preheating stage; the display shows "PrEh". When the preheating is complete, a "BEEP" sounds to indicate that cooking can start. (If START is not pressed after the beep, the temperature is held constant for about 10 minutes, after which it will start to drop for a period up to a maximum time of 20 minutes, counted from when the beep sounded. During this stage, the display shows the parameters of the selected program). ­ although this is not recommended in terms of cooking quality, the program can be started even before the preheating temperature is reached by pressing START. During cooking, the display shows the time left until the end of the cooking process and the temperature set. During the last minute of cooking, the 25 Instructions for the user display will only show the countdown from 60 to zero seconds (end of cooking time). When all the cooking time has passed, a BEEP will sound for 20 seconds and the display will show "End". During these 20 seconds the user can extend the cooking time as required, in manual mode, as follows. Press START; the display will show "tp00". From now on, each pressure on the START key corresponds to one more minute's cooking; up to 10 extra minutes are permitted. Cooking will restart at the programmed temperature after 5 seconds. When these additional minutes have passed the program repeats the cooking end procedure exactly as described above and after the 20-second BEEP the word "End" will flash for 20 minutes, during which time the temperature will gradually fall, stabilising at 100°C. After 20 minutes, the oven switches off. 4. 5 Manual cooking Use the knob to select the "easy" program (P10 *). The special feature of this user-editable program is that the cooking parameters set are not retained in the memory when the knob is turned to any other position. [. . . ] The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the oven from its power supply. 6. 1 Replacing the light bulb Remove the protective cover A. Refit the protective cover A. Use only oven light bulbs (suitable for a temperature of up to 300°C). 31 Instructions for the user 6. 2 Removing the door Hinges with mobile connecting plates Grip the door at the two sides with both hands in proximity to hinges C and lift up the small levers D. Lift the door upwards at an angle of about 45° and slide out. To remount, insert hinges C into the appropriate grooves, allow the door to settle downwards and release the small levers D. Hinges with mobile levers Open the door completely and take the door in both hands holding it at the sides close to the hinges. [. . . ]