User manual SMEG ALFA41XE2

[. . . ] WE URGE YOU TO READ THIS MANUAL AND ALL THE INFORMATI ON IT CONTAINS CAREFULLY BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS OVEN IS INTENDED FOR PROFESSIONAL USE AND CONFORMS TO THE EEC DIRECTIVES CURRENTLY IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD; ALL OTHER USES ARE CONSIDERED IMPROPER. [. . . ] The adjustment screws have a range of 10 mm. 2. 4 Steam outlet pipe An exhaust pipe is fitted on the back of the oven to allow the discharge of steam during cooking. Avoid crushing them. 22 Instructions for the User 3. DESCRIPTION OF CONTROLS START BUTTON This button lets you start cooking operations or perform a rapid cooling cycle when they are finished. In the steam model it starts the humidification cycle. STOP BUTTON This button lets you stop cooking at any time. DISPLAY Allows to view the selected program and the cooking parameters of the selected program. PROGRAM SELECTION KNOB Allows to set the cooking operation using one of the preset programs, to select the temperature and duration of the cooking operation. 23 Instructions for the User 4. USING THE OVEN 4. 1 Warnings and general advice When using the oven for the first time, heat it up to its maximum temperature for a duration long enough to burn off any oily residues from the manufacturing process. To access food, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food. 4. 2 Choice of programs This appliance allows you select 40 cooking programs including: · 38 programs that can be edited and saved as the user wishes · 1 manual program "P40" · 1 preheating program with delayed start "P39" 4. 3 Editing / saving a program The oven has 38 programs that can be modified by the user from P01 to P38. To set the operational parameters of a program: · · · · · · Turn the knob to the or symbols to select the program you wish to save / edit. Keep the "PUSH" knob pressed for 3 seconds: the display will show the cooking temperature. Turn the knob to the or symbols to set the cooking temperature. Press the "PUSH" knob: the display will show the cooking time. Turn the knob to the or symbols to set the cooking time (from 1 to 99 min). Press the "PUSH" knob to exit from the data setting and saving phase. The message "PEnd" will appear on the display and the parameters will be saved. After 3 seconds the display will show the parameters set in rotation. To return to the "OFF" status keep the "STOP" button pressed for 4 seconds. · · 24 Instructions for the User 4. 4 Running a program From the "OFF" status proceed as follows: · Turn the knob to the or symbols to select one of the available programs from P01 to P38. The display will show the parameters of the selected program in rotation. To start the program press the "START" button. The appliance will perform a preheating cycle, showing the message "PrEh" on the display. When preheating is finished, a series of beeps lasting 3 seconds indicate that is possible to proceed with the cooking operation. The message "PrEh" will flash on the display. To start the cooking, keep the "START" button pressed for 2 seconds. The display will show, in order, the temperature set, the time remaining until the end of cooking and the program selected. [. . . ] Use absorbent kitchen roll; in case of stubborn dirt remove with a damp sponge and an ordinary detergent. 30 Instructions for the User 6. EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before performing any operations, switch off the power supply to the oven. 6. 1 Changing the light bulb Remove the bulb protector A. [. . . ]