User manual SMEG BD328

[. . . ] ENGLISH Installation, use and maintenance instructions GB 2 STANDARDS-WARNINGS AND RECOMMENDATIONS Thank you for purchasing one of our appliances. Please read these notes thoroughly as they have been written to help you obtain the maximum performance from the appliance. The quality of the appliance is guaranteed as each one of our products is fully tested as it comes off the production line. Use the appliance and you will see just how much satisfaction you will get. [. . . ] 3c Anchor the upper part of the appliance, using the screws supplied, in the pre-drilled panel over the front fascia. 9 When installing the appliance, remember the following: A Do not install it near to sources of heat such as heaters, radiators, cookers, etc. B Make sure that during the automatic defrost, any water on the back wall of the compartment runs into the drain channel. C After the appliance has been placed in its final position, leave it for about an hour before connecting it to the power supply. D Make sure that the appliance is working properly before placing any food in it. WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES AND LEAVE A GAP OF AT LEAST 5 CM ABOVE IT INSTALLATION IN THE TALL UNIT HOUSING The dimensions of the tall unit housing must correspond to those reported in the figure. 3a Insert the appliance in the housing against the side 907 3d 3e 3f B A 3i 3g 3h 10 POSITIONING AND INSTALLING THE APPLIANCE 3d Anchor the centre of the appliance to the wall of the unit using the special brackets. 3e Fix the two bottom feet in the holes in the base of the unit. 3f Where provided, apply the plastic joint gasket. GB 3g Check that the guides of door opener "A" are positioned opposite the opening, otherwise remove them and replace on the other side. 3h Fix guides "B", supplied, on the fridge unit door in the first hole to allow the guide to rotate until it engages fridge door opener "A". 3i Then screw in the other two fixing screws to fix opener "B", such that the guide is blocked and that the door moves together with that of the unit. 907 Green and Yellow to Earth 13 amp Fuse Brown to Live Blue to Neutral Cord Clamp GB ELECTRICAL CONNECTION Check that the mains voltage complies with that indicated on the rating plate located on the bottom left of the freezer compartment. If the mains socket does not have an earth connection or if the plug is not suitable for the mains supply system, refer to a qualified electrician. Do not use adapters or extension leads, as these may overheat and burn. 11 Warning: this appliance must be earthed If the appliance has been fitted with a non-rewirable plug of the incorrect type for the mains socket, cut off the plug and fit a new one. Inserting an unsuitable plug into a 13 Amp socket is likely to cause an electrical hazard. When a non rewirable plug or rewirable 13 Amp (BS1363) plug is used, it must be fitted with a 15 Amp ASTA approved (BS1362) fuse. If any other type of plug is used it must be wired as follows. Connect the GREEN & YELLOW wire to the earth terminal marked with the letter "E" or coloured green or green & or earth symbol, yellow. Connect the BLUE wire to the neutral terminal marked with the letter "N" or coloured black. Connect the BROWN coloured wire to the live terminal marked with the letter "L" or coloured red. 907 6 5 4 3 2 1 12 USING THE FRIDGE COMPARTMENT CONTROL CONTROL PANEL 1 BUTTONS: - ON / OFF - Temperature control - SUPER mode activation 2 GREEN LED MINIMUM POSITION 3 GREEN LED MEDIUM POSITION 4 GREEN LED MAXIMUM POSITION 5 YELLOW LED super MODE 6 RED LED ALARM FUNCTION (FREEZER) GB When cleaning the internal compartments and accessories, follow the instructions reported in chapter " Cleaning ". DESCRIPTION OF THE APPLIANCE The appliance consists of two cells: - A fridge (upper part) for storing fresh food and drinks - A freezer (lower part) for long-term storing of frozen products (bottom compartment) and for freezing fresh products (top compartment). BEFORE STARTING THE FRIDGE 907 1 T1 S6 S2 GB USING THE FRIDGE COMPARTMENT the green led (S2) (minimum position) . If the freezer compartment is warm, the red led (S6) (alarm) starts to flash, and turns off automatically when the freezer compartment reaches the temperature of -12°C . 13 CONNECTING THE APPLIANCE TO THE MAINS SUPPLY Check that the mains voltage corresponds to that indicated on the appliance's rating plate and that the mains socket is equipped with an earth connection. If the appliance is switched off then immediately back on again, the compressor will start to operate after approximately 10 minutes. START-UP AND CONTROL OF REFRIGERATOR COMPARTMENT On insertion of the plug in the mains socket, if the green led (S2) (minimum position) does not light, this means that the appliance is switched off. [. . . ] - Clean using a domestic vacuum cleaner or a brush. A dirty condenser will have a negative effect on the appliance and reduce its performance. For prolonged absences - Empty the compartments. 907 R V GB CLEANING 21 Cleaning the water drain When cleaning the condenser, check that the rear drain pipe R is not blocked. - Remove drain pipe R from the container V and if necessary clean it. Power supply cable - Periodically inspect the power cable to check its condition. - If the cable is damaged, do not use the appliance and do not attempt any repairs. [. . . ]