User manual SMEG C7172FP
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SMEG C7172FP. We hope that this SMEG C7172FP user guide will be useful to you.
Lastmanuals help download the user guide SMEG C7172FP.
Manual abstract: user guide SMEG C7172FP
Detailed instructions for use are in the User's Guide.
[. . . ] • At first installation or after reversing the door wait at least 4 hours before connecting the appliance to the power supply. • Do not install the appliance close to radiators or cookers, ovens or hobs.
WARNING!• Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the electrical components (e. g. [. . . ] • The refrigerant circuit and the insulation materials of this appliance are ozonefriendly. Contact your municipal authority for information on how to discard the appliance correctly. • Do not cause damage to the part of the cooling unit that is near the heat exchanger.
1 2 3 4
Temperature indicator LED FROSTMATIC indicator FROSTMATIC button Temperature regulator ON/OFF button
1. Touch the temperature regulator button if all LED are off.
• • • •
room temperature frequency of opening the door quantity of food stored appliance location.
Keep touching the temperature regulator button for 3 seconds. All indicators light off.
To operate the appliance, touch the temperature regulator until the LED corresponding to the required temperature lights up. Choose the setting keeping in mind that the temperature inside the appliance depends on:
1. Any time you touch the temperature regulator, the setting moves by one position. Touch the temperature regulator until the required temperature is selected.
You can activate FROSTMATICfunction by pressing the FROSTMATIC button. You can deactivate FROSTMATICfunction by pressing the FROSTMATIC button again. Refer to Safety chapters.
Cleaning the interior
Before using the appliance for the first time, the interior and all internal accessories
should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish.
Do not move the glass shelf above the vegetable drawer to ensure correct air circulation.
Freezing fresh food
The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. In addition, remove pieces of ice with an ice scraper before defrosting is complete. Wait at least 3 hours before putting the food back into the freezer compartment.
Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions: 1. If you want to keep the appliance switched on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
WARNING!Refer to Safety chapters.
What to do if. . .
Problem The appliance does not operate. Refer to "Closing the door".
Possible cause The FROSTMATIC is switched on.
Solution Refer to "FROSTMATIC function". Refer to "Closing the door".
There is too much frost and ice.
The door is not closed correctly or the gasket is deformed/dirty. Temperature is set incorrectly.
Position the water drainage plug in the correct way. The compressor starts after a period of time.
The compressor does not start immediately after pressing the FROSTMATIC, or after changing the temperature. Water flows inside the refrigerator.
This is normal, no error has occurred.
During the automatic defrosting process, frost melts on the rear plate. [. . . ] Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SMEG C7172FP
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SMEG C7172FP will begin.