User manual SMEG C92DX

[. . . ] PRECAUTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RECYCLING INSTRUCTIONS - OUR ENVIRONMENT POLICY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INTENDED USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It flashes at regular intervals to indicate that the temperature inside the oven is being kept constantly at the set level. AUXILIARY OVEN THERMOSTAT KNOB The cooking temperature is selected by turning the knob clockwise to the required setting, between 50° and 245°C. The light comes on to indicate that the oven is heating up. This light goes out when the set temperature is reached. It flashes at regular intervals to indicate that the temperature inside the oven is being kept constantly at the set level. LAMP TOP AND BOTTOM HEATING ELEMENTS BOTTOM HEATING ELEMENT GRILL ELEMENT WIDE GRILL ELEMENT END OF COOKING TIMER KNOB This knob allows to select manual cooking or the timer: the oven switches off automatically at the end of cooking. If no cooking duration is selected, the timer knob must be positioned on the symbol . 9 Instructions for the user 8. USING THE HOB 8. 1 Lighting the hob burners Before lighting the hob burners, check that the flame-spreader crowns are correctly in place with their respective burner caps, making sure that the holes A in the flame-spreaders are aligned with the plugs and thermocouples. Before lighting the burners lift the glass lid; before closing it again, turn off all the burners and wait for them to cool. The optional grid B is for use with woks. To prevent damage to the hob, the cooker comes complete with a raised pan stand C for use underneath pans more than 26 cm in diameter. The pan stand C supplied is for use even with small pans. The burner each knob controls is shown next to the knob. The appliance is equipped with an electronic ignition device. Simply press the knob and turn it anti-clockwise to the minimum flame symbol , until the burner lights. Keep the knob pressed down for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: in this case, the thermocouple has not heated up sufficiently. Repeat the operation, keeping the knob pressed down for longer. This is not necessary on burners not equipped with thermocouple. On models with thermocouple, if the burners should go out accidentally a safety device will be tripped, cutting off the gas supply even if the gas tap is open. 8. 2 Practical hints for using the hob burners For better burner efficiency and to minimise gas consumption, use pans with lids and of suitable size for the burner, so that flames do not reach up the sides of the pan (see paragraph "8. 3 Pan diameters"). Once the contents come to the boil, turn down the flame far enough to prevent the liquid from boiling over. To prevent burns or damage to the hob during cooking, all pans or griddle plates must be placed inside the perimeter of the hob. All pans must have smooth, flat bottoms. Take the greatest care when using fats or oils since they may catch fire if overheated. If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to re-light the burner. 8. 3 Pan diameters BURNERS 1. [. . . ] When the installation is complete, the installer must provide a certificate of conformity. 13. 4 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance using flexible bayonet style hose in accordance to B. S. The hose connection at the rear of the appliance has a ½" BSP internal thread. Always use a suitable sealing substance (such as Teflon tape) between the flexible connection L and the appliance supply tube B. When making the connection, make sure that no stress of any kind is applied to the cooker and that the hose does not touch any sharp edges. [. . . ]