User manual SMEG CI54

[. . . ] 36 BEFORE INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 DESCRIPTION OF FRONT PANEL CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 USING THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 USING THE PIZZA FUNCTION (ON SOME MODELS ONLY) . . . . . . . . . . . . [. . . ] Now you can also select the cooking function required and wait for the buzzer to sound, indicating that the cooking time is over. You can now set an additional cooking time by turning PT1, or return to display of the current time by pressing PT1 twice. Turn PT2 to the "0" symbol to switch the oven off completely. The minute minder also works with no function set. 40 Instructions for the user Warning. The minute minder does not stop the cooking process. It only warns the user that the preset number of minutes have passed. To switch the oven off completely, turn PT2 to the "0" symbol. Modifying the data set Once the countdown has started, its duration can be changed while cooking is in progress. When the symbol is steady, press PT1 once. The symbol starts flashing and PT1 can be turned to change the set duration. A few seconds after the last change, the symbol will stop flashing, and the countdown will restart from the new value. Changing the settings of the secondary menu parameters is very easy. Refer to the chart below: MENU MODIFICATION PROCEDURE SYMBOLS Turn PT1 to the right to increase (+) the value or set ON status . Turn PT1 to the left to decrease (-) the value or set status . Press PT1 to move on to setting of the next parameter in the menu. After setting P3, pressing PT1 returns to normal oven operation. Off 44 Instructions for the user 7. 7 Cooling fan system The appliance is equipped with a cooling system which comes into operation as soon as a cooking function or a cleaning cycle (Pyrolysis) starts. Operation of the fans generates a normal air flow which comes out above and underneath the door and may continue for a short time even after the oven is switched off. 7. 8 Inside light The oven light comes on: · when the function knob is turned to any function. Turning it to the left, it goes out. 45 Instructions for the user 8. USING THE PIZZA FUNCTION (ON SOME MODELS ONLY) This appliance is equipped with a function specially developed for cooking pizza. This function is identified by the symbol on the oven functions knob. To cook a pizza, proceed as described below. With the oven cold, remove the circular cover from the bottom of the oven (fig. [. . . ] To reassemble, fit the hinges into their grooves, then lower the door into place and extract the pins. 12. 3 Removing the gasket To allow thorough cleaning of the oven, the door gasket can be removed. 57 Instructions for the user 12. 4 Removing the inside glass with the door cold The glass in the door should always be kept thoroughly clean. For easier cleaning, the door glazing can be fully removed by proceeding as described below. After opening the door and locking it in place as described in point "12. 2 Removing the door", remove the three panes of glass. All extracted in two stages: first extract the pane from the guide "A" (see detail) by sliding it towards you and lifting it slightly, then also free it from the guide "B". [. . . ]