User manual SMEG CR322ANFL

[. . . ] The fan can be deactivated by pressing the button on the base (as shown in the figure). If the room temperature exceeds 27°C, the fan must be on in order to guarantee the correct preservation of food. Deactivation of the fan enables energy consumption to be optimised. Intermediate Medium-low Low (colder) What to do if. . . Possible causes: There may be an appliance power supply problem. Cures: Make sure: - there is not a power outage - the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position (i. e. allows the appliance to be powered) - the household electrical system protection devices are efficient - the power cable is not broken. [. . . ] 3. After the new bulb has been inserted, replace the lamp cover and wait five minutes before plugging the appliance back in. Lighting type 2) To remove the light bulb, turn anticlockwise as shown in the figure. Wait for 5 minutes before reconnecting the appliance. 2 1 Lighting type 3) If the product has LED lighting which is in need of replacing, contact the After-Sales Service for assistance. LED lights last longer than normal bulbs, they illuminate better and are more environmentally friendly 10 WHEN THE APPLIANCE IS NOT IN USE Unplug the appliance from the mains, then empty, defrost (if necessary) and clean it. Leave the doors ajar, so that air can circulate inside the compartments. This will prevent the formation of mould and bad odours. DURING BLACKOUTS Keep the doors closed to allow the stored food to stay cold as long as possible. If the blackout persists, the blackout alarm may sound (depending on the model). REFRIGERATOR COMPARTMENT The refrigerator compartment is designed for the storage of fresh food and beverages. Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall of the compartment indicate that the periodic automatic defrost cycle is in progress. The defrost water is automatically routed to a drain outlet and into a container from which it evaporates. Depending on the model, the appliance may have a special box (“Meat & Fish” or “Zero Degrees”) which is ideal for the storage of fresh meat and fish. For other models, if frost forms in the freezer compartment, we recommend it is defrosted twice a year or whenever an excessive amount of frost has formed (3 mm thickness). It is perfectly normal for frost to form. The amount of frost which forms and the rate at which it builds up depends on room temperature and humidity, and on how often the door is opened. To defrost, unplug the appliance and remove all foodstuffs. Leave the door ajar to allow the frost to melt. For products with a freezer compartment below the refrigerator compartment, the defrost water drain pipe can be removed (see figure) and a recipient placed underneath. After defrosting, replace the drain pipe, making sure that no water is left in it. Clean inside the freezer compartment and dry carefully. Switch the appliance back on and place the food back inside. 12 MEAT & FISH BOX (depending on model) The Meat & Fish box was designed specially to keep foods fresher for longer, without altering nutritional values or original freshness. Do not store fruit or vegetables in this box, as the temperature may drop below 0°C, causing water contained in the food to freeze. Temperature Adjustment The temperature inside the Meat & Fish box is indicated by the position of the arm on the door of the box, and depends on the general temperature of the refrigerator compartment. We recommend setting the temperature of the refrigerator compartment between +2° and +6°. [. . . ] Never use abrasive detergents. AFTER-SALES SERVICE Before contacting the After-Sales Service: Switch the appliance on again to see if the problem has been solved. If it has not, unplug the appliance and wait for about an hour before switching on again. If the appliance is still not working after you have gone through all the checks listed in the troubleshooting guide and switched it off then on again, contact the After-Sales Service to explain the problem and have the following information ready: • the type of fault • the model • the type and serial number of the appliance (given on the rating plate) • the Service number (the number after the word SERVICE on the rating plate inside the appliance) Note: the door opening direction can be changed. If this operation is performed by the After-Sales Service it is not covered by the warranty. ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. [. . . ]