User manual SMEG CVI38X

[. . . ] · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. · Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse. · When disconnecting the appliance, pull on the plug, not on the cable. [. . . ] This appliance must be earthed. The under-worktop mutli-temperature wine cabinet Wines only develop their full flavour and aroma when they are at the right temperature for drinking. In your multi-temperature wine cabinet, wines can be brought slowly and evenly to the ideal drinking temperature. Red wines and white wines can be stored at the same time at the optimal drinking temperature in two separately adjustable temperature zones. Installation dimensions (mm) Adjust to recess height using the 4 adjustable feet on the underside of the appliance. The ventilation cross-section in the plinth panel must be min. 300 cm². 7 Operating and control elements On/Off button Fan button Interior light on/off button Audible warning on/off button Child lock display Upper compartment temperature display Lower compartment temperature display Lower compartment activation button Upper compartment activation button Temperature setting buttons Additional functions Switching the appliance on and off You are recommended to clean the appliance before switching it on for the first time (see "Cleaning"). To switch the appliance on: Press the ON/OFF button until the temperature display lights up. To switch the appliance off: Keep the ON/OFF button pressed for 3 sec. so that the temperature display goes out. Setting the temperature Activating set-up mode: · Press the FAN button for approx. · Select the required function by pressing the UP/DOWNbutton: · Now select/acknowledge the function by pressing the FAN button briefly: > For c = child lock, press the UP/DOWN button to select c1 = child lock on or c0 = child lock off and acknowledge with the FAN button . When the symbol is lit, the child lock is activated. > For h = brightness, press the UP/DOWN button to select h1 = minimum to h5 = maximum brightness and acknowledge with the FAN button . Exiting set-up mode: Exit the set-up mode by pressing the ON/OFF button ; after 2 min. the electronic system switches over automatically. The normal operating mode is activated again. c = child lock, h = display brightness In set-up mode you can set the child lock and adjust the brightness of the display. The child lock is designed to protect the appliance from being switched off accidentally. The temperature of both compartments can be set separately. Select the appropriate compartment by pressing button or . The respective temperature display flashes. To reduce the temperature: Press the DOWN button. To increase the temperature: Press the UP button. The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. Audible warning signal - It sounds when the door has been left open for longer than about 60 seconds. - It sounds when the interior gets too warm or too cold. The temperature display will also flash. [. . . ] Please note that noises caused by the refrigerant circuit cannot be avoided. The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")?­ Does the separately installed thermometer show the correct reading?­ Is the ventilation system working properly? [. . . ]