User manual SMEG CWH521SD-1

[. . . ] 3 Disposing of the worn out appliance Placing and installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Choosing the right place Connection to Power Supply Adjusting the height of the appliance 4 Maintenance and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Freezer defrosting Cleaning the appliance Switch off the appliance when not in use Description of the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operating the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] • If the power supply cord is damaged, it must be replaced by the manufacturer or his service agent or a qualified person in order to avoid hazard. • The rating plate is located in the interior or on the rear wall of the appliance. Ventilation slots on the appliance or a built-in element must always be clean and unobstructed. Do not use mechanical devices or tools to defrost the refrigerator, nor any other methods except for those recommended by the manufacturer. Instructions for Use 3 • Warning!When installing, cleaning, or removing the appliance, make sure the insulation on the refrigeration system parts is not damaged. Thus you will also prevent damage to the environment. Do not use electric appliances in the refrigerator or freezer interior, except for those expressly allowed by the refrigerator-freezer manufacturer. • After the installation, the appliance mains plug should be accessible!The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of thisproduct. Settings towards the thinner part of the marking mean a higher temperature (warmer). Selecting the temperature in the appliance Recommended setting for the thermostat knob A is half way between the thinner and the thicker end of the sign. Signal light D will flash when the temperature in the freezer rises to a level that is too high, and goes off when the temperature drops back to a level that no longer represents food spoilage hazard (see section »Troubleshooting«). Freezing and storing frozen food Freezing process Maximum quantity of fresh food that can be introduced into the appliance at a time is indicated on the label with basic information on the appliance. If this quantity is exceeded, freezing quality will deteriorate, as will the quality of the already frozen food. • When freezing smaller quantities of food (1-2 kilograms), activating the super freeze function is not required. • After the end of the freezing process, rotate the A dial back to the desired setting, even if the B signal light is not on (this means that sufficiently low temperature has already been reached. • If the freezer boost is not deactivated manually, it will be automatically switched off after approximately 2 days. Then the temperature of the freezer compartment returns to the most ). recently set value (knob position remains at Important warnings on freezing fresh food • The freezer should only be used for freezing food that is appropriate for freezing. The food should always be fresh and of adequate quality. • Choose an appropriate packaging for the food and package it correctly. • The packaging should be airtight and watertight to prevent loss of humidity or vitamins from the food. • Indicate the type of food, quantity, and freezing date on each food package. [. . . ] • Remove the screws fixing the appliance to the kitchen worktop. • Pull out the appliance to expose the condenser at the back of the appliance. • Unscrew the screws from the condenser bonnet and remove the bonnet. • Clean the dust and dirt from the condenser. Cleaning of the condenser Dust from the condenser unit should be vacuumed in the following manner: − push your finger through the opening in the bottom rail and release the fastener; − pull the rail towards you and remove it; − remove the bottom board of the kitchen cabinet; − pull out the condenser dish; − use a vacuum cleaner to clean the dust from the condenser; − replace the condenser dish and the bottom rail in the opposite order. After you have cleaned the appliance, reconnect it to the power mains and put the food packages back to their place. After cleaning return the appliance to its place, plug in the power cord and fill with food. Switch off the appliance when not in use If you do not intend to use the appliance for a longer period of time, disconnect the power supply, empty the appliance, defrost it and clean it. [. . . ]