User manual SMEG CXL91VG

[. . . ] The brackets should be fixed with the round end at the bottom. Once the brackets are screwed to the wall the hood can be hooked on. HOW TO USE Use in external evacuation (ducted) version (fig. 3) The cooking fumes are passed to the atmosphere through a ducting system. The air outlet on top of the hood must be connected to the external exhaust ducting. [. . . ] The air outlet on top of the hood must be connected to the external exhaust ducting. To connect the hood to the ducting use the connection flange supplied. Open the grille panel and check that the convertible knob is in the DUCTING position (fig. The charcoal filter is not required when the hood is in the exhuast mode. The ducting should not be turned through every tight bends as this may impair the performance of the hood. Internal recirculation version (filtering) (fig. 4) In this mode air is passed through a charcoal filter to be purified and recirculated into the room through the grille above the facia. Open the grille panel and check to convertible knob is in the RECYCLING (fig. 5) position and that the charcoal filter is fitted over the plastic grille supporting the motor. Models with two motors require two charcoal filters. The metal grease filters should be washed once a month in hot water using mild detergent or liquid soap. It should not be bent and should be left to dry before being refitted. The filter is easily removed from grille by pushing the spring wire clips to one side and removing. Charcoal filter In the recycling mode the charcoal filter absorbs smells and odours. The charcoal filter cannot be cleaned and should be replaced at least every six months or more frequently if the hood is used consistently. To replace the charcoal filter, support the filter with one hand, remove the thumb screw (fig. 10) through the centre of the charcoal filter and the filter will come away. It is a possible fire hazard if the filters are not cleaned and replaced as recommended. Worktop illumination If a lamp fails to function at any time, open the metal grille panel and check that the lamp is fully screwed into the holder. When changing the lamp, an identical replacement must be fitted to ensure a safe working of the hood. [. . . ] Worktop illumination If a lamp fails to function at any time, open the metal grille panel and check that the lamp is fully screwed into the holder. When changing the lamp, an identical replacement must be fitted to ensure a safe working of the hood. Cleaning The metalwork should be cleaned regularly, at least once a month, using household cleaners and polish. Important For cooker hoods featuring an earth cable, make sure the electric plant of your house is correctly earthed. [. . . ]