User manual SMEG DRY2005.1

[. . . ] Tumble Dryer Thank you for your trust and for buying our tumble drier. We hope it will successfully serve its purpose for many years. This appliance was designed for drying clothes, for home use only. Laundry dried in the tumble drier is dried quickly, is soft and smooth and does not change the shape during drying. With a tumble drier, there is no need for an extra room and no need for ropes and waiting for a sunny day. Instructions for Use should be of some help to you therefore it is recommendable to read them carefully and to keep in an adequate place. [. . . ] The distance between the dryer and venting opening (airduct or window) must not exceed two meters, otherwise condense can accumulate in the tube, (Fig 5). 1 2 Vent pipe can be bought in any technical store (identification code PIPE SP-377628). B - Condenser - type Dryer Do not install the condenser dryer into the room where a danger of freezing can occur. Freezing of water in the condensed water drawer and the pump can damage the appliance. 4 5 Positioning This dryer is a self standing appliance and can stand alone, or it can be placed either together with a washing machine or in the kitchen as a kitchen unit. If the floor is uneven, use the adjustable feet to level the machine. 1 Decorative cap 2 Vent pipe B ­ Condenser - type Dryer Humidity from the laundry in the condenser dryer is extracted into the air cooler and accumulated in the drainage container or conducted directly into the moist air outlet. After every drying the condensed water drawer should be emptied, of which you are reminded by the control lamp which is on when the container is full. The air cooler should be cleaned in time (see the chapter Maintenance and Cleaning) 3 3a Undo the nuts. Rotate the feet to level the machine (fig. 3a). Instructions for Use 19 Channelling the condenser tube to the drain outlet Take off the condensed water drawer tube from the rear side of the dryer and by fitting an elbow on it channel the tube into the drain outlet. Height of the drain must not exceed 800 mm. Connecting to Power Supply The appliance is connected to the power supply by means of a cable cord plug. The wall socket should be earthed (safety socket). Required nominal current and frequency are stated on the rating plate. The wiring should withstand maximum load. Electric connection and earthing should be carried out in accordance with current standards and regulations. IMPORTANT In the supply cord is damaged, it must be replaced by the manufacturer or his service agent or a qualified person in order to avoid hazard. · The appliance should be placed in the position, where the plug is within reach. Door Door of the dryer can be opened by pressing the door frame against the machine, as shown in the figure. The door is closed in the same way, If the door is not closed properly the machine will not operate. Be careful not to pinch the laundry with the door as it might get damaged. IMPORTANT You may open the door during drying. The operation of the machine is interrupted, but it goes on as soon as you close the door. 20 Instructions for Use Description of the Appliance Extractor dryer 1. 12. 3 9 1 10 11 8 Control panel Condensation receptacle Door Air cooler Vent aperture Cooling air aperture Adjustable legs Filter Time selection button and ON / OFF button Control lamp Low drying temperature selector Signal lamp ­ condensation receptacle 5 9 6 7 10 11 12 Condensation dryer 9 1 12 10 11 2 8 3 4 6 7 Instructions for Use 21 Drying Drying programme selection clements are fited in the control panel as well as the indicator light which is on during the operation of the machine. ON/OFF and Drying Time Selection Rotate the knob clockwise. Preparing the Laundry for Drying · Sort the laundry before drying according to type of the laundry. · Do the buttons, zippers, join the strings and pull out the pockets. · Very delicate laundry (fine underwear with laces) should prior to drying be put in a special sack so that it won't get damaged by buttons, zippers and pins. [. . . ] So once a year, wipe the dust in the interior of the drier. Cleaning procedure - Pull the plug out of the wall socket. - Clean (suck out) the moist air outlet through the opening on the rear or side wall (A) and the vent pipe. - Undo the screws and remove the cover (B). - Clean (with a vacuum cleaner) the bottom of the drier and parts on the bottom. [. . . ]