User manual SMEG DWD44SS

[. . . ] • Take care that no objects are stuck in the doors. • Do not use the appliance to heat rooms for any reason. • Remove the doors and leave the accessories (racks and trays) in their usual working positions, so that children cannot get stuck in the oven compartment. • Cut the power supply cable and remove it along with the plug. [. . . ] To re-arm the safety device press the button on the back. Contact technical support immediately after the safety device has triggered to check if there are any faults. 24 Use 3 Use 3. 1 Instructions High temperature inside the oven during use Danger of burns • Keep the oven door closed during cooking. • Protect your hands wearing heat resistant gloves when moving food inside the oven. • Do not touch the heating elements inside the oven. • Do not pour water directly onto very hot trays. • Do not allow children to get near the oven when it is in operation. • If you need to move food or at the end of cooking, open the door 5 cm for a few seconds, let the steam come out, then open it fully. High temperature inside the oven during use Danger of fire or explosion • Do not spray any spray products near the oven. • Do not use or leave flammable materials near the oven. • Do not use plastic kitchenware or containers when cooking food. • Do not put sealed tins or containers in the oven. • Do not leave the oven unattended during cooking operations where fats or oils could be released. To remove the door proceed as follows: 1. Open the door completely and insert two pins into the holes on the hinges indicated in the figure. 4. 2 Cleaning the surfaces To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. 4. 3 Ordinary daily cleaning Always use only specific products that do not contain abrasives or chlorine-based acids. Pour the product onto a damp cloth and wipe the surface, rinse thoroughly and dry with a soft cloth or a microfibre cloth. 2. Grasp the door on both sides with both hands, lift it forming an angle of around 30° and remove it. 27 EN Cleaning and maintenance 4. 7 Removing the internal glass panels For easier cleaning the door internal glass panels can be disassembled. Remove the internal glass panel by pulling the rear part gently upwards, following the movement indicated by the arrows (1). In this way, the 4 pins attached to the glass detach from their housings in the oven door. 3. To reassemble the door, put the hinges in the relevant slots in the oven, making sure that grooved sections A are resting completely in the slots. Lower the door and once it is in place remove the pins from the holes in the hinges. 3. Clean the external glass panel and the panels previously removed. In case of stubborn dirt, wash with a damp sponge and neutral detergent. 4. 6 Cleaning the door glazing The glass in the door should always be kept thoroughly clean. [. . . ] To prevent safety hazards for users, all technical inspections or repairs must be carried out by qualified personnel. Unscrew the rear casing screws and remove the casing to access the terminal board. Make sure that the cables follow the best route in order to avoid any contact with the appliance. 5. 2 Positioning Heavy appliance Danger of crush injuries • Position the appliance with the aid of a second person. Pressure on the open door Risk of damages to the appliance • Never use the open door to lever the appliance into place when fitting. [. . . ]