User manual SMEG FA100AP

[. . . ] 6 Temperature indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 CLEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Replacing The Light Bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · The plug should be accessible after the appliance is positioned. · Manufacturer is not responsible for failure to complete the ground connection as described in this booklet. · Do not place the appliance in direct sunlight. · Do not use in open air and shall not be exposed to the rain. · Place the refrigerator far from heat sources and in a wellventilated position. The refrigerator should be at least 50 cm from radiators, gas or coal stoves and 5 cm far from electrical stoves. · Keep the top free for at least 15 cm. · Do not place heavy and lots of things on the appliance. · If the appliance is installed next to another refrigerator or freezer, observe a miminum distance of 2 cm to prevent condensation. · Do not put very (!) hot food or bowl on the top table. · Fit the plastic wall spacers to the condenser at the back of the refrigerator in order to prevent leaning to the wall for good performance. · The appliance must be stand firmly and level on the floor use levelling-feet to compensate for an even floor. · The outside of the appliance and the accessories inside should be cleaned with a solution of water and liquid soap; the inside of the appliance with sodium bicarbonate dissolved in lukewarm water. After drying replace all the accessories. Before Switching On · Wait after 3 hours before plugging the appliance in to the power to ensure proper performance. · There can be an odor when you first switch on the appliance. It will disappear after the appliance starts to cool. THE VARIOUS FUNCTION AND POSSIBILITIES Thermostat Setting · Thermostat automatically regulates the inside temperature of the refrigerator compartment and freezer compartment. By rotating the knob from position 1. to 5. , colder temperatures can be obtained. · « 0 » position shows thermostat is closed and no cooling is available. · For short-term storage of food in the freezer compartment, you can set the knob between minimum and medium position. (1-3) · For long-term storage of food in the freezer compartment, you can set knop medium position. (3-4) Note that; the ambiant temperature, temperature of the freshly stored food and how often the door is opened, affects the temperature in the refrigerator compartment. If required, change the temperature setting. · When you first switch on the appliance, for starting a suitable cooling, the appliance should work 24 hours continuously until it cools down to sufficient temperature. [. . . ] If there is water in the lower part of the refrigerator ; Check that ; The drain hole for defrost water is not clogged(Use defrost drain plug to clean the drain hole) If your fridge is not cooling enough; Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to the climate class stated in the information label. We do not recommend operating your fridge out of stated temperatures value limits in terms of cooling effectiveness. Climate Class T ST N SN Recommendations · In order to increase space and improve the appearance, the « cooling section » of refrigerators is positioned inside the back wall of the refrigerator compartment. When the appliance is running, this wall is covered with frost or water drops, according to weather the compressor is running or not. [. . . ]