User manual SMEG FA395B

[. . . ] Instructions for use Refrigerator Thank you for your confidence in buying our appliance and congratulations on the excellent choice. We hope it will successfully serve its purpose for many years. The refrigerator is used in households for storage of fresh food at temperatures exceeding 0°C. Before first operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The nominal voltage and frequency is indicated on the relevant label or rating plate of the appliance. · Mains power connection and earthing must be made in accordance to standard regulations and requirements. The appliance is able to accommodate minor temporary voltage fluctuations which do not exceed -10% to +6%. · Use the power cord to connect the appliance to 7 142396 Reverse door swing Required tools; socket spanner nr. After unscrewing of before fixing hinges, hold the door to prevent it from falling and damaging. Remove upper hinge cover (keep it for eventual later use), together with cover on the opposite side of the upper hinge cover (on the opposite side you will insert the attached cover during the assembly), and remove the cover on the opposite side of the upper part of the door. Unscrew upper hinge screws and remove the door from the bottom hinge. On the bottom side of the door unscrew the swing stopper screws and remove the stopper (A) keep this stopper for later use. Fix the attached stopper with its bearing on the opposite side of the door. Unscrew the forced door closure system (B) and fix it to the opposite side of the door (certain models only). Remove handle screw covers, unscrew handle screws, and remove plastic pegs on the opposite side. 35°) to lean to the rear side of the cabinet. Unscrew the leg support screws (C) - left and right, and remove the leg support cover (D). Unscrew and remove, then reciprocally replace the position of end switch (E) and decorative peg (F) (for models with forced door closing system). Unscrew three screws fixing the bottom hinge (keep the hinge for later use), and fix the attached bottom hinge on the opposite side. Proceed with the assembly procedure in opposite sequence. 142396 8 Control panel The description refers to the appliance with all available accessories, so that it could contain certain settings our model may not have. Control unit A Temperature selector and ON/OFF button B Green LED: illuminated when the appliance is in operation C The Digital temperature display indicates actual temperature inside the appliance from +1°C to +9°C (certain models only). 9 142396 The ON/OFF button The appliance is switched on by turning the button (A) towards Max. The appliance is switched off when the arrow on the button points to the ON/OFF mark (the appliance, however, is still under mains power). Setting the temperature · Temperature of the appliance is set by turning the · · · · button (A) to the position between the Min and Max span. Recommended setting of the thermostat knob is to Eco position (around +5°C in appliances with digital display). If the room temperature, in which the appliance is installed, is lower than 16°C, the recommended setting of the thermostat knob is to the Max. . The digital display (certain models only) flashes and indicates set temperature. When flashing stops, setting is completed and the temperature is automatically saved in memory. (Please allow time to reach this desired temperature. ) Each time the appliance is switched on for the first time, the digital display (C) indicates temperature of +9°C and flashes. This value remains on display until the actual temperature falls below the indicated value. [. . . ] Free the sensor and allow air to circulate around it. · Check air circulation for sufficient cooling of the compressor, and clean the condenser. Excessive ice formation at the rear interior wall of the refrigerator: · Frequent opening of the door, door open too long. · Placing hot food in the refrigerator. [. . . ]